Reinstalling software – Panasonic CF-W2 Series XP Manuel d'utilisation

Page 60

Advertising
background image

Reinstalling Software

60

Troubleshooting

z

To divide the hard disk into two partitions (for OS and data)
Press the

2

key.

Enter the basic partition size (GB) for the operating system installation
and press the

Enter

key.

• You can cancel this operation by pressing the

0

key.

• The data partition size is the remainder after subtracting the basic

partition size. (Data partition: 1 GB or more)
Maximum settable size differs depending on the model.

z

To reinstall Windows in the original partition without changing the parti-
tion configuration
Press the

3

key.

• The first partition size must be 6 GB or more of the hard disk size.

Reinstallation cannot be performed with a small partition size.

<When the hard disk backup function has been enabled>
If you select [1] or [2], the message [The Backup function has been enabled.
If [Recovery] is executed, the Backup function will be disabled, and your
Backup data will be lost.] appears. In this case, press the

Y

key.

If the message [Computer must be rebooted in order to execute [Recovery.]]
appears, press the

R

key.

D

At the confirmation message, press the

Y

key.

z

The operation of reinstallation for the hard disk starts automatically.
(The operations take about 20 minutes.)

z

Do not interrupt the reinstallation procedure before completion, for
example by turning off the computer or pressing the

Ctrl

+

Alt

+

Del

key, as this may prevent Windows from starting up, or may cause data
to be lost so that the reinstallation procedure cannot be executed.

E

The message "[Recovery] is complete" will be displayed. Remove the
Product Recovery DVD-ROM, and press any key to shut down the com-
puter.

4

Return the Setup Utility settings to their default values.

Return the Setup Utility to its settings at the time of shipment to ensure
proper setup of Windows.

A

Turn on the computer, and press the

F2

key while [Panasonic] boot

screen is displayed.
The Setup Utility will start up.
If the password has been set, enter the Supervisor Password, and press
the

Enter

key.

B

Press the

F9

key.

At the confirmation message, select [Yes] and press the

Enter

key.

C

Press the

F10

key.

At the confirmation message, select [Yes] and press the

Enter

key.

The Setup Utility will close, and the computer will restart.

Advertising