Problem solving, Troubleshooting, If you have any of these problems – Panasonic UF-885 Manuel d'utilisation

Page 157

Advertising
background image

155

PROBLEM SOLVING

Troubleshooting

If You Have Any of These Problems

Mode

Symptom

Cause / Action

page

During Standby

The display is blinking

The battery is not installed or the battery is completely
discharged. Install a New battery and reset the clock.

24

During Transmission

Document doesn't
feed/multiple feed

1. Check that your document is free of staples and paper

clips, and that it is not greasy or torn.

2. Check that your document is the right type to send through

a fax machine by consulting the list on "Documents You
Cannot Send". If your document has the characteristics
listed, make a photocopy of your document and send the
copy instead.

3. Check that the document is loaded properly.
4. Adjust the ADF Pressure.

39

40

164

Document jam

The information code 031 will appear on the display if the
document becomes jammed.

161

Does not stamp

1. Check if Stamp LED is lit.
2. Check Fax parameter No. 04 and No. 28 settings.

42

35,36

Stamp too light

Replace stamp or refill ink.

165

Transmission Copy
Quality

Vertical lines on the
transmitted document

Check own copy quality. If copy is OK, your machine has no
problem, report to the receiving party that they have a
problem. If copy is NG, clean the Document Scanning Area.

162

Transmitted document
is blank

1. Make sure the document is set face down.
2. Check own copy quality. If copy is OK, your machine has

no problem, report to the receiving party that they have a
problem. If copy is NG, clean the Document Scanning
Area.

162

During Reception

No recording paper

The information code 010 will appear on the display if the
paper runs out.

18

Recording paper jam

The information code 001, 002, 003, 007 or 008 will appear on
the display if the paper gets jammed.

160

Recording paper
doesn't advance into
machine

Make sure that there is paper in the Paper Cassette. Follow
the instructions for loading paper.

18

Recording paper
doesn't eject after
printing

Check to see if the recording paper is jammed inside of the
machine.

160

Recording papers are
not stacked in
sequence. Machine
does not print from the
last page received.

1. Check if Fax Parameter No. 65 is set to valid.
2. If memory becomes full during reception, the machine will

start to print from the 1st page received. We recommend
that optional flash memory card is installed if this symptom
occurs frequently.

38

173

Document auto
reduction doesn't work

Check Print Reduction settings.

61

Out of toner

The information code 041 will appear on the display if the
Toner Cartridge runs out of toner.

16

8

Advertising
Ce manuel est liée aux produits suivants: