Panasonic CF-07 - Manuel (Page 33)

33
T
roubleshooting
Press F9 in the Setup Utility ( “Setup Util-
ity”). This will restore the Setup Utility’s settings to their
default values (except the password settings).
Try removing all peripheral devices.
Windows 98
Run SCANDISK to check the hard disk.
At start-up, press Ctrl to operate the computer in the
Safe mode.
Windows 2000
Click [Local Disk(C:)] in [My Computer] with the right
button, select [Properties], then select [Tools] - [Check
Now].
At start-up, press F8 to operate the computer in the
Safe mode.
Restart the computer by using the keyboard (e.g., or
Ctrl
+ Esc ).
When the port replicator is not connected, turn off the com-
puter.
Use the Windows password as the following.
Select [Start] - [Settings] - [Control Panel] - [Power Man-
agement]* - [Advanced], then add the check mark for
[Prompt for password when computer goes off standby].
*
Windows 2000 : [Power Options]
Press the Menu button of the wireless display, then set the
password (
Operating Instructions of the wireless dis-
play).
A problem possibly occurred during startup. After power-
ing off the computer, connect the port replicator and restart
the computer.
After powering off the computer, connect the USB floppy
disk drive and restart the computer.
After reinstalling, setup Windows, then set the password again.
When the previous
item is not the cause
The cursor cannot be
controlled
The password is not
required when re-
suming from the
standby or hiberna-
tion mode
T h e D I S P L A Y
READY indicator
does not go on even
when the HDD indi-
cator goes off
Windows 98
When starting up in
the MS-DOS mode,
the USB floppy disk
drive can not be used
Windows 2000
The password of the
administrator was
forgotten
Starting Up