Panasonic CF-07 - Manuel (Page 23)

23
Getting Started
Windows 98
Be sure to prepare the following.
• Optional port replicator (CF-VEB071)
• External keyboard
• External display
When using the files in the following folders available on the retail version of the Win-
dows CD-ROM, it is necessary to run a separate file decompression program.
\tsclient
\tools
To uncompress the file, it is necessary to have approximately 80 MB of free disk space
available on the hard disk.
To use the CD-ROM drive in MS-DOS mode, perform the operation below after modi-
fying config.sys and autoexec.bat (
“CD-ROM Drive”).
File decompression method:
1 Turn on your computer.
2 When [Press <F2> to enter SETUP] is displayed, immediately press Ctrl (until
the menu is displayed).
3 Select [Command prompt only].
4 Insert the Product Recovery CD-ROM.
5 At the prompt, input the following:
L:\en\addfile
Enter
Follow the message on the screen.
After this program is executed, the contents of the above folders will be decompressed
to the c:\util\win98add folder.
Windows 2000
When a new device has been installed or a new Windows Component has been added in
[Start] - [Settings] - [Control Panel] - [Add/Remove Programs], [Insert Disk] may ap-
pear. Select [OK] and specify [c:\winnt\cdimage] in place of [c:\sysprep\i386] or [D:],
then select [OK].
e.g. [c:\winnt\cdimage\i386] in place of [D:\i386]
NOTE
22
Windows 98
Select [Start] - [Settings] - [Control Panel] - [Network] - [TCP/IP PRISM2
IEEE 802.11 PC CARD Adapter] - [Properties] - [IP Address], set the param-
eters by following the above <Step 3>
screen, then select [OK].
Windows 2000
Select [Start] - [Settings] - [Control Panel] - [Network and Dial-up Connec-
tions] -[Local Area Connection 2] - [Properties] -[Internet Protocol (TCP/IP)] -
[Properties], set the parameters by following the above <Step 3>
screen, then
select [OK].
23 Restart the computer.