Panasonic WV-CW864A - Manuel (Page 7)

-7-
■ Camera Cleaning
Even if this function is used, noise may be produced on
the monitor screen, or the preset position may deviate
in the course of prolonged use.
In such cases, activate the refresh mode on the special
2 menu. (See page 42.)
To use this camera with WJ-SX550C, WJ-SX150 Matrix
Switcher, set the auto cleaning function activated on the
Matrix Switcher side, then clean WV-CW864A one time
a day.
■ Preset Data Uploading or Down-
loading
To download the preset data from the camera to the
controller or upload the downloaded data to the cam-
era, set the following functions to OFF.
Downloading or uploading the data may not work nor-
mally if these functions are set to ON.
• Alarm (see page 31)
• Preset alarm (see page 33)
• Cleaning (see page 32)
• Motion detection (see page 39)
• Auto mode (see page 23)
• Self return (see page 23)
Aim the camera at a motionless object such as a wall, if
possible, to download or upload the preset data.
Note: Take notice of the following when uploading the
downloaded data to the camera.
• Preset positions may vary. If a preset position has
deviated, delete the preset position and set the cor-
rect preset position newly.
• Uploading of WV-CW864A preset data to other mod-
els (e.g. WV-CW864, WV-CS854, WV-CS854A and
WV-NS324) may cause an error and failure of the
uploading process.
PRECAUTIONS
1. Do not attempt to disassemble the camera.
To prevent electric shock, do not remove screws or
covers.
There are no user-serviceable parts inside.
Ask a qualified service personnel for servicing.
2. Handle the camera with care.
Do not misuse the camera. Avoid striking, shaking,
etc. The camera could be damaged by improper
handling or storage.
3. Consult an expert on the load bearing capacity of
the installation surface and structure. If the sur-
face is not strong enough, the camera may fall
down. Refer to the product specifications for
weights.
4. Do not install the camera in places where it will
be exposed to corrosive gasses, e.g., in chemical
plants, seaside, at swimming pools or the like.
Otherwise corrosion of the bracket may cause
the camera to fall down.
5. Use the fall-prevention wires to reduce the risk of
the camera falling down.
Do not detach the fall-prevention wire securing the
camera. Otherwise the camera could fall down,
causing injury to persons and damage to the cam-
era.
6. Do not use strong or abrasive detergents when
cleaning the camera body.
Use a dry cloth to clean the camera when it is dirty.
When the dirt is hard to remove, use a mild deter-
gent and wipe gently. Care should be taken not to
scratch the dome cover when wiping it.
Afterwards, wipe off the remaining detergent with a
dry cloth.
7. Never aim the camera at the sun.
Whether or not the camera is in use , never aim it at
the sun or other extremely bright objects. Otherwise,
blooming or smear may be caused.
8. Never aim the camera at strong light sources for
an extended period of time.
Alight source such as a spot light causes burn-in on
the display screen. Failure to observe this may
cause the image to become discolored due to dete-
rioration of the color filter in the CCD.
9. Do not aim the camera at the same object for a
long time.
Burn-in of an image may be caused on the fluores-
cent screen of CRT.