Panasonic WV-CW864A - Manuel (Page 39)

-39-
● Motion Detector (MOTION DET)
1. Move the cursor to MOTION DET and select ON or
OFF with the joystick.
2. If ON is selected, press the CAM (SET) key. The
MOTION DETECT menu appears.
You can mask the areas in this menu.
3. Move the cursor to MASK SET and press the CAM
(SET) key. 48 mask areas appear on the monitor
screen.
Refer to Light Control Setting on page 35 for mask-
ing operations.
4. After masking areas, press the MON (ESC) key. The
MOTION DETECT menu appears on the monitor
screen.
5. Move the cursor to ALARM and select ON or OFF
with the joystick.
ON: The alarm signal is supplied while the display
mode is activated.
OFF: The alarm signal is not supplied while the dis-
play mode is activated.
6. Move the cursor to DISPLAY MODE.
Press the CAM (SET) key to see the present setting.
The areas that detect the motions blink.
7. Move the cursor to LEVEL with the joystick.
Obtain the optimum detection level with the joystick.
Note: Repeat the above procedure until you obtain
the adjusted results.
8. Dwell Time
Move the cursor to DWELL TIME, and select a time
with the Joystick.
When the time specified here elapses after motion
detection, the camera will notify the connected
device of the alarm activation. The default setting is
2 seconds.
Selectable times (seconds): 2s, 5s, 10s, 30s
9. Move the cursor to RECOVER TIME with the joystick.
You can select the following recover times.
10. Move the cursor to RET and press the CAM (SET)
key to return to SET UP.
Important Notices:
• The motion detection should meet the following con-
ditions.
1) The picture size on the screen should be larger
than 1/48 of the actual picture size.
2) The contrast ratio between the object and the
background picture should be more than 5 % at
the maximum detection level.
3) The time that takes the object to move from one
end of the screen to the other should be more
than 0.1 second.
• Also under the following conditions, mask or adjust
the detection level to prevent malfunction.
1) When leaves, curtains, etc. are swayed by the
wind.
2) When a picture has a high noise content due to
low light conditions.
3) When the object is illuminated by lighting equip-
ment that constantly turns on and off.
** SET UP **
CAMERA ID
ALC/MANUAL
SHUTTER
AGC
SENS UP
SYNC
WHITE BAL
MOTION DET
AF MODE
RET SPECIAL2
OFF
ALC
AUTO
ON(MID)
OFF
INT
ATW1
ON
AUTO L
** MOTION DETECT **
LEVEL
DWELL TIME 2S
DISPLAY MODE
ALARM OFF
MASK SET
RECOVER TIME
RET
•••|•••••
- +
1MIN
2MIN 3MIN 5MIN 10MIN
60MIN 30MIN 20MIN
1MIN
OFF