Attaching the front panel 8, About the demo mode 8, Reverse mode 8 – Pioneer DEH-P6500 Manuel d'utilisation

Page 8: Feature demo 8, About the operation mode 8, About the demo mode, About the operation mode, Before you start

Advertising
background image

Attaching the front panel

% Replace the front panel by holding it

upright to this unit and clipping it securely

into the mounting hooks.

About the demo mode

This unit features two demonstration modes.

One is the reverse mode, the other is the fea-

ture demo mode.

! You cannot cancel a demo mode when the

front panel is open.

Important

The red lead (ACC) of this unit should be con-
nected to a terminal coupled with ignition switch
on/off operations. If this is not done, the vehicle
battery may be drained.

Reverse mode

If you do not perform an operation within

about 30 seconds, screen indications start to

reverse, and then continue reversing every 10

seconds. Pressing 5 numbered button when

power to this unit is turned off while the igni-

tion switch is set to ACC or ON cancels the re-

verse mode. Pressing 5 numbered button

again to start the reverse mode.

Feature demo

The feature demo automatically starts when

power to this unit is turned off while the igni-

tion switch is set to ACC or ON. Pressing 6

numbered button during feature demo opera-

tion cancels the feature demo mode. Pressing

6 numbered button again to start the feature

mode. Remember that if the feature demo

continues operating when the car engine is

turned off, it may drain battery power.

About the operation mode

This unit features two operation modes, opera-

tion mode 1 and 2. Operation mode 1 enables

you to operate all the functions of this unit.

Operation mode 2 enables you to operate the

basic functions for each source easily. This

manual explains operation mode 1. Please

refer to Using the operation mode 2 on page 35

for operation mode 2.

Before You Start

En

8

Section

01

HHHHHHHHHHHHHH

Advertising