Adjusting loudness 30 using subwoofer output 30, Adjusting subwoofer settings 30, Using non fading output 30 – Pioneer DEH-P6500 Manuel d'utilisation

Page 30: Adjusting loudness, Using subwoofer output, Using non fading output, Audio adjustments, Adjusting subwoofer settings

Advertising
background image

Adjusting loudness

Loudness compensates for deficiencies in the

low- and high-sound ranges at low volume.

1 Press AUDIO to select Loud.

Press AUDIO until Loud appears in the dis-

play.

2 Press a to turn loudness on.

Loudness level (e.g., Loud Mid) appears in the

display.

3 Press c or d to select a desired level.

Each press of c or d selects level in the fol-

lowing order:

Low (low)Mid (mid)High (high)

4 Press b to turn loudness off.

Loud OFF appears in the display.

Using subwoofer output

This unit is equipped with a subwoofer output

which can be turned on or off.

1 Press AUDIO to select Sub-W1.

Press AUDIO until Sub-W1 appears in the dis-

play.

# When the subwoofer controller setting is
PREOUT :FULL, you cannot select Sub-W1.

2 Press a to turn subwoofer output on.

Sub-W1 Normal appears in the display. Sub-

woofer output is now on.

# To turn subwoofer output off, press b.

3 Press c or d to select the phase of sub-

woofer output.

Press c to select reverse phase and Rev. ap-

pears in the display. Press d to select normal

phase and Normal appears in the display.

Adjusting subwoofer settings

When the subwoofer output is on, you can ad-

just the cut-off frequency and the output level

of the subwoofer.

1 Press AUDIO to select Sub-W2.

Press AUDIO until Sub-W2 appears in the dis-

play.

# When the subwoofer output is on, you can se-
lect Sub-W2.

2 Press c or d to select cut-off frequency.

Each press of c or d selects cut-off frequen-

cies in the following order:

5080125 (Hz)

Only frequencies lower than those in the se-

lected range are output from the subwoofer.

3 Press a or b to adjust the output level

of the subwoofer.

Each press of a or b increases or decreases

the level of the subwoofer. +6  6 is displayed

as the level is increased or decreased.

Using non fading output

When the non fading output setting is on, the

audio signal does not pass through this units

low pass filter (for the subwoofer), but is out-

put through the RCA output.

1 Press AUDIO to select non fading out-

put on/off setting.

Press AUDIO until NonFad ON appears in the

display.

# When the subwoofer controller setting is only
PREOUT :FULL, you can switch to the non fading
output on/off setting. (Refer to page 33.)

2 Press a to turn non fading output on.

NonFad ON appears in the display. Non fad-

ing output is now on.

# To turn non fading output off, press b.

Audio Adjustments

En

30

Section

07

HHHHHHHHHHHHHH

Advertising