Connecting antennas, Using external antennas, Connecting up 02 – Pioneer ELITE SX-A6MK2-K Manuel d'utilisation

Page 9: English

Advertising
background image

Connecting up

02

9

En

English

2

Connect the analog outputs of your tape

deck (or other recorder) to the TAPE inputs
(IN) on this receiver. Then connect the audio
inputs on the tape deck to the TAPE outputs
(OUT) on this receiver.
This will allow you to make recordings from the
components connected to this receiver. Use
stereo RCA phono cables as shown.

3

Turntables only:

Connect the audio

outputs of your turntable to the PHONO
inputs on this receiver.

• If your turntable has a grounding wire,

secure it to the ground terminal on this
receiver.

• If your turntable has line-level outputs (i.e.,

it has a built-in phono pre-amp), connect it
to the AUX inputs instead.

Connecting antennas

Connect the AM loop antenna and the FM wire
antenna as shown below. To improve reception
and sound quality, connect external antennas
(see Using external antennas below).

1

Pull off the protective shields of both AM

antenna wires.

2

Push open the tabs, then insert one wire

fully into each terminal, then release the tabs
to secure the AM antenna wires.

3

Fix the AM loop antenna to the attached

stand.
To fix the stand to the antenna, bend in the
direction indicated by the arrow then clip the
loop onto the stand (fig. a).

• If you plan to mount the AM antenna to a

wall or other surface, secure the stand with
screws (fig. b) before clipping the loop to
the stand. Make sure the reception is clear.

4

Place the AM antenna on a flat surface

and in a direction giving the best reception.

5

Connect the FM wire antenna in the same

way as the AM loop antenna.
For best results, extend the FM antenna fully
and fix to a wall or door frame. Don’t drape
loosely or leave coiled up.

Using external antennas

To improve FM reception

Use a 75

Ω coaxial cable to connect an external

FM antenna.

To improve AM reception

Connect a 5 m to 6 m (15 ft. to 18 ft.) length of
vinyl-coated wire to the AM antenna terminal
without disconnecting the supplied AM loop
antenna.

For the best possible reception, suspend
horizontally outdoors.

ANTENNA

FM UNBAL

75

AM LOOP

3

1

2

4

5

fig. a

fig. b

ANTENNA

FM UNBAL
75

AM LOOP

One-touch
PAL connector

75

Ω coaxial cable

ANTENNA

FM UNBAL
75

AM LOOP

Outdoor
antenna

Indoor antenna
(vinyl-coated wire)

5 m to 6 m

(15 ft. to 18 ft.)

A6MK2_CUXCN.book 9 ページ 2009年4月15日 水曜日 午前10時26分

Advertising