Pioneer ELITE SX-A6MK2-K - Manuel (Page 19)

Other connections 06
19
En
English
Connecting an IR receiver
If you keep your stereo components in a closed
cabinet or shelving unit, you can use an
optional IR receiver (such as a Niles or Xantech
unit) to control your system instead of the
remote sensor on the front panel of this
receiver.
1
1 Connect the IR receiver sensor to the IR IN
jack on the rear of this receiver.
2 Connect the IR IN jack of another
component to the IR OUT jack on the rear of
this receiver to link it to the IR receiver.
Please see the manual supplied with your IR
receiver for the type of cable necessary for the
connection.
• If you want to link a Pioneer component to
the IR receiver, see Operating other Pioneer
components with this unit’s sensor below
to connect to the CONTROL jacks instead
of the IR OUT jack.
Operating other Pioneer
components with this unit’s
sensor
Many Pioneer components have SR CONTROL
jacks which can be used to link components
together so that you can use just the remote
sensor of one component. When you use a
remote control, the control signal is passed
along the chain to the appropriate component.
• Note that if you use this feature, make sure
that you also have at least one set of analog
audio jacks connected to another
component for grounding purposes.
1 Connect the CONTROL OUT of this
receiver to the CONTROL IN jack of another
Pioneer component.
Use a cable with a mono mini-plug on each
end for the connection.
2 If the Pioneer component also has a
CONTROL OUT jack, you can continue the
chain in the same way for as many
components as you have.
Note
1 • Remote operation may not be possible if direct light from a strong fluorescent lamp is shining on the IR receiver remote
sensor window.
• Note that other manufacturers may not use the IR terminology. Refer to the manual that came with your component to check
for IR compatibility.
• If using two remote controls (at the same time), the IR receiver’s remote sensor takes priority over the remote sensor on the
front panel.
Closet or shelving unit
AUX1 AUX2 CD PHONO
MM/MC
R
L
GND R
L
CONTROL XM
IN
IN
SIGNAL
OUT IR
OUT
Non-Pioneer
component
IN
IR
Pioneer
component
This receiver
IR receiver
IN OUT
CONTROL
GND
L
CONTROL
SIGNAL
OUT
IR
OUT
IN
CONTROL
OUT
Pioneer component
Pioneer
component
remote
control
This receiver
CD PLA YER
A6MK2_CUXCN.book 19 ページ ２００９年４月１５日 水曜日 午前１０時２６分