Pioneer AVIC-N3 - Manuel (Page 13)

<CRD4069A/U> 13
Be sure to use only the supplied extension lead. Use of another lead could
cause fire, smoke and/or damage this product.
12
ENG/MASTER 96
English
Español
Deutsch
Français
Italiano
Nederlands
Note:
Cords for this product and those for other products may
be different colors even if they have the same function.
When connecting this product to another product, refer
to the supplied Installation manuals of both products
and connect cords that have the same function.
Power cord
Black, Orange/white, Red, Yellow
☞
See Page 9.
Yellow/black (GUIDE ON)
When combining this navigation system with the
other Pioneer audio unit for the vehicle, if the vehicle
stereo has yellow/black leads, connect them to those
leads. In this way, when the guidance audio is output
and when you operate the system by voice, the vehi-
cle stereo is automatically muted to reduce the vehi-
cle stereo volume.
Violet/white (REVERSEGEAR SIGNAL INPUT)
This is connected so that the navigation system can
detect whether the vehicle is moving forwards or
backwards. Connect the violet/white lead to the
lead whose voltage changes when the shift lever is
put in reverse. Unless connected, the sensor may
not detect your vehicle traveling forward/backward
properly, and thus the position of your vehicle
detected by the sensor may be misaligned from the
actual position.
Note: When you use the ND-PG1 speed pulse
generator (sold separately), please make sure
to connect it.
When you use a rear view camera, please make
sure to connect it. Otherwise you cannot switch to
rear view camera picture.
☞
See Page 15.
Connection method
Clamp the reversing lamp
lead.
Clamp firmly with
needle-nosed pliers.
Reversing lamp lead
Fuse resistor
Check the position of your vehicle’s
reversing lamp (the one that lights up
when the shift lever is in reverse [R])
and find the reversing lamp lead in the
trunk.
Display unit
Extension lead
(for reverse signal) 5 m (16 ft. 5 in.)
CRD4069-A_U_inst_001_031_US 10/25/05 10:58 Page 13