Pioneer S-HTD510 - Manuel (Page 31)

31
En
8 Using the Timer
9 Set the switch off time.
Set in the same way as the switch on time, pressing
ENTER to finish.
• If you make a mistake, press SYSTEM SETUP and
start again from step 3.
10 Check the settings you just made.
The display should indicate that you have set the wake
up timer, then show the on time, the off time, the
function (DVD, etc.), and the volume. The display
shows
CHECK END after all the settings.
• There is no direct way to edit the timer settings. If
you see that some timer setting is not what you’d
intended, you’ll need to start the process again from the
top.
11 Switch the system into standby.
The timer will not work if the system is left on!
The timer indicator ( ) lights when the timer is on.
Activating/deactivating the wake up
timer
To activate the wake up timer, set the timer to ON . To
deactivate it, set the timer to OFF .
1 Press SYSTEM SETUP.
2 Press
2 or 3 until you see TIMER in the
display.
3 Press ENTER.
4 Press the
2 or 3 button until you see
TIMER ON or TIMER OFF in the display.
5 Press ENTER.
The timer indicator ( ) lights when the timer is on.
Using the wake up timer
You can use the timer as an alarm clock to wake up to
the sound of a disc loaded or the radio. If you have an
external component operated by a separate timer, you
can also set it as the source function.
Once the timer is active, it will switch the system on
everyday at the set time.
Unlike an ordinary alarm clock, you need to set a
system switch off time, as well as a switch on time.
1 Select the source that you’d like to wake
up to.
For a disc, press
DVD / CD ; for the radio press TUNER /
BAND ; for an external component, press TV / AUX .
2 Load a disc or tune to a radio station,
then set the volume.
If you selected an external component, make the
appropriate timer settings for it.
3 Press SYSTEM SETUP.
4 Press
2 or 3 until you see TIMER in the
display.
5 Press ENTER.
6 Press
2 or 3 until you see WAKE UP SET
in the display.
7 Press ENTER.
The display shows a switch on time with the hour
blinking.
8 Set the switch on time.
Use
5 and ∞ to set the hour then press
ENTER . Set the
minute in the same way, pressing ENTER to finish.
• If you make a mistake, press SYSTEM SETUP and
start again from step 3.