Pioneer S-HTD510 - Manuel (Page 22)

22
En
Getting Started 5
• Manual tuning
To change the frequency one step at a time, press the
1 / ¡ buttons. When you locate a station signal,
the
(tuned) indicator lights in the display.
• High-speed tuning
Press and hold the
1 or ¡ button for high speed
tuning, releasing the button once you reach the
frequency you want. When you stop on a station signal,
the
(tuned) indicator lights in the display.
Improving FM stereo sound
If you’re listening to a stereo FM broadcast, but find that
there is a lot of noise because of a weak signal, try
switching to mono.
• Press MONO (SHIFT & 5) to switch
between mono and stereo.
When listening in mono, the
indicator lights in the
display.
Saving station presets
If you often listen to a particular radio station, it's
convenient to have the receiver store the frequency for
easy recall whenever you want to listen to that station.
This saves the effort of manually tuning in each time.
This system can save up to 30 station presets. When
saving FM frequencies, the receiver also saves the mono
setting (see Improving FM stereo sound above).
1 Tune to a station you want to memorize.
See Listening to the radio on page 21 for more on how
to do this.
2 Press SYSTEM SETUP.
3 Press
2 or 3 until you see ST. MEMORY
appear in the display.
4 Press ENTER.
5 Press
2 or 3 to select a station preset
number.
Alternatively, use the number buttons (use the >10
button for numbers over 10).
If you use the number buttons, you can skip step 6.
6 Press ENTER again to save the station
preset.
Repeat these steps to save up to 30 station presets.
Listening to station presets
Having saved up to 30 station presets, you can be
listening to a station with a couple of button presses.
1 Press TUNER/BAND to switch to the
tuner.
If you’re using the front panel controls, press
TUNER /
BAND repeatedly to select the preset station mode.
2 Use
4 or ¢ to select the station
preset you want to listen to.
Alternatively, use the number buttons (use the >10
button for numbers over 10).
• If the system is left disconnected from the AC power
outlet for a lengthy period, the station presets will be lost
and will have to be reprogrammed.
Listening to other components
You may have connected your TV, VCR, or other
components to play through this system. Use the
TV /
AUX button to select your external equipment as the
source.
1 Press TV/AUX.
Press repeatedly to switch between:
• TV inputs
• DIGITAL input
• AUX analog inputs
2 Start playing the source component.