Logitech Jabra BH970 - Manuel (Page 17)

BH970 Wireless Mono DECT Headset User’s Guide 17
5.5 Base Keypad
The BH970 Base keypad displays information about the headset and call status, and has controls for call handling. From here,
you can change target phone, answer an incoming call, end the current call, configure base settings, or open an audio link to
the current target phone.
8
7
5
4
3
1 2
6
1. Battery icon – indicates the current battery level.
2. Headset docking icon – indicates the headset is docked.
3. Audio link icon – indicates audio link between base and headset
is active.
4. Mute icon – indicates the headset microphone is muted.
5. Mute button – mutes/unmutes the headset microphone.
6. Group call icon – indicates desk phone and communication
software calls are merged.
7. Phone state icon – indicates desk phone or communication
software call states.
8. Phone buttons – used for desk phone and/or communication
software call handling.
5.6 Base Keypad Visual Indicators
Icon Event Icon Event
Battery charging Current target phone
Full battery Phone ringing
Low battery Phone on call
Very low battery Phone on hold
Headset docked Phone unplugged
Unknown headset docked Group call
Headset and base pairing
Audio link between headset
and base is active
Muted Unable to connect to headset
5.7 Base Audio Indicators
The base speaker is located on the bottom of the BH970 Base, and plays two distinct sounds.
Incoming Call Ringtone
Adjust the incoming call ringtone volume using the Jabra Control Center.
1. Launch Jabra Control Center and select either the Desk phone or Softphone tab.
2. Adjust the Base speaker ring tone level slider to the desired setting, and click Apply.
Keypad Button Clicks
Tapping, double-tapping, or pressing the keypad buttons will play a “click” sound. Adjust keypad button volume via the Jabra
Control Center. The default setting is off.
1. Launch the Jabra Control Center and select either the Desk phone or Softphone tab.
2. Select one of four preset keypad click settings (off, low, medium, or high), and click Apply.