KITCHENAID 9763393A - Manuel (Page 9)

9
7. Install the vent system according to the method needed. Use
caulking to seal the exterior wall or roof opening.
8. Determine wiring knockout.
To wire through the top wiring knockout:
Measure and mark a parallel line either 10 ⁵⁄₈" (27 cm) for the
30" (76.2 cm) hood or 11
⁵⁄₈" (29.5 cm) for the 36" (91.4 cm)
hood to the right of the centerline on the cabinet ceiling. Mark
a point on this line that is 4" (10.2 cm) from the back wall of
the cabinet. Drill a 1
¹⁄₄" (3.2 cm) diam. hole through the
cabinet ceiling.
To wire through the rear wiring knockout:
Measure and mark a parallel line 11 ³⁄₈" (29.8 cm) for the
30" (76.2 cm) hood or 14 ³⁄₈" (36.5 cm) line for the
36" (91.4 cm) hood to the right of the centerline on the
cabinet back wall. Mark a point on this line that is 8
¹⁄₄" (21 cm)
from the bottom of the cabinet. Drill a 1 ¹⁄₄" (3.2 cm) diam.
hole through the wall.
9. Run the wiring through the wall or cabinet according to the
national Electrical Code and all local codes and ordinances.
Use caulking to seal around wire opening.
NOTE: Do not turn on power until installation is complete.
10. Measure the thickness of the cabinet floor, including the filler
strips, if used. If the thickness is less than ⁵⁄₈" (15.9 mm),
install wood filler strips that are a minimum length of
5" (12.7 cm) onto the cabinet floor. The mounting bracket
adjusts from
⁵⁄₈" (15.9 mm) to 2¹⁄₈" (54 mm) for the wood filler
strips.
11. Remove the vent hood from the carton. Attach the damper to
the vent opening. If the roof cap or wall cap has a damper, do
not attach the damper to the vent hood.
12. Remove the top or rear knockout from the wiring opening,
depending on which one will be used.
A. Wiring cutout
A. Wiring cutout
A
A
A. Less than
⁵⁄₈
" (15.9 mm)
B. Wood fillers (thickness as required)
A. Damper
A. Wiring knockouts
B
A
WARNING
Excessive Weight Hazard
Use two or more people to move and install
range hood.
Failure to do so can result in back or other injury.
A
A