Sony STR-DA50ES - Manuel (Page 39)

39 GB
Receiving Br
oadcasts
Automatic Tuning
For details on the buttons used in this section, see “Brief
descriptions of buttons and controls used to receive
broadcasts” on page 38.
1 Rotate FUNCTION to select the tuner.
The last received station is tuned in.
2
Press FM/AM to select the FM or AM band.
3
Press TUNING (PTY SELECT) + or TUNING (PTY
SELECT) –.
Press the + button to scan from low to high; press the –
button to scan from high to low.
When the receiver reaches either end of the
band
Scanning is repeated in the same direction.
The receiver stops scanning whenever a station is
received.
4
To continue scanning, press TUNING (PTY SELECT) +
or TUNING (PTY SELECT) – again.
Direct Tuning
Use the supplied remote to perform the
following operations
For details on the buttons and controls used in this
section, see the operating instructions for the supplied
remote.
1
Rotate FUNCTION to select the tuner.
The last received station is tuned in.
2
Press FM/AM to select the FM or AM band.
3 Press DIRECT (or D.TUNING).
4
Press the numeric buttons to enter the frequency.
Example 1: FM 102.50 MHz
b b b b 1 0 2 5 0
Example 2: AM 1350 kHz
(You don’t have to enter the last “0.”)
b b b 1 3 5 0
If you cannot tune in a station and the
entered numbers flash
Make sure you’ve entered the right frequency. If not,
repeat Steps 3 and 4.
If the entered numbers still flash, the frequency is not
used in your area.
5
If you’ve tuned in an AM station, adjust the
direction of the AM loop antenna for optimum
reception.
6
Repeat Steps 2 to 5 to receive another station.
z
If you try to enter a frequency that is too precise for the
tuning scale
The entered value is automatically rounded up or down.
Tuning scale for direct tuning is:
FM: 50 kHz
AM: 9 kHz