Placing the camera on the cyber-shot station, Removing the camera from the cyber-shot station – Sony CSS-TNA Manuel d'utilisation

Page 10

Advertising
background image

10-GB

Placing the camera on
the Cyber-shot Station

Attach the camera, as refering to the image
below.

– Insert the “Memory Stick Duo” into the

camera. When you use data in the internal
memory, do not insert the “Memory Stick
Duo” into the camera.

– Be sure to turn off the camera before placing

it on or removing it from the Cyber-shot
Station.

– Make sure that the camera is securely

attached to the Cyber-shot Station.

Removing the camera
from the Cyber-shot
Station

– Hold the Cyber-shot Station down when you

remove the camera from the Cyber-shot
Station.

Insulation sheet

Preparing the remote control

Notes on the remote control
• The remote control is powered by a button

type lithium battery (CR2025) installed at the
factory. An insulation sheet is inserted to
avoid the battery exhaustion. Remove the
insulation sheet before using the remote
control for the first time.

• Point the remote sensor of the Cyber-shot

Station away from strong light sources such
as direct sunlight or overhead lightings.
Otherwise, the remote control may not
function properly.

• The remote control range is less than five

meters (for indoor use). Point the remote
control at the remote sensor of the Cyber-
shot Station. Try adjusting the angle of the
remote control if you cannot operate the
Cyber-shot Station.

Advertising