Samsung DVD-R170 - Manuel (Page 14)

14_ getting started
getting started
Connecting the Power Cord
After all connections are complete, plug the power cord into a wall outlet.
Preparing the Remote Control
If the remote control does not operate properly:
Check the polarity +/- of the batteries.
Check if the batteries are drained.
Check if the remote sensor is blocked by obstacles.
Check if there is any fl uorescent lighting nearby.
Dispose of batteries according to local environmental regulations.
Do not put them in the household trash.
You can then control the television using the following buttons.
Button Function
TV POWER Used to switch the television on and off.
INPUT SEL. Used to select an external source.
TV VOL +/- Used to adjust the volume of the television.
CH ( ,.) Used to select the desired channel.
0~9 Used to input number directly.
100+ Button Used to select channels over 100.
You can control only Samsung TV with this remote control.
The various functions may not be able to be controlled on all televisions. If you encounter problems, operate the
television directly.
•
•
•
•
M 

Installing batteries in the Remote Control
1. Lift the cover at the back of the
remote control upward as shown.
2. Install two AAA size batteries.
Make sure to match the “+” and “–”
ends of the batteries with the diagram
inside the compartment.
3. Replace the cover.
Assuming typical TV usage,
the batteries last for about one
year.
01580A-R170-XAZ-ENG.indb 14 01580A-R170-XAZ-ENG.indb 14 2008-06-10 오후 5:00:03 2008-06-10 오후 5:00:03