Getting started, Operating this unit, About operation mode – Sony XDP-210EQ Manuel d'utilisation

Page 4: Selecting the stored equalizer curve, Setting and storing the equalizer curve

Advertising
background image

4

Actual total number:

Sony XDP-210EQ (E) 3-856-153-12 (1)

EN

Getting Started

Operating this unit

You can control this unit by a Sony Master
unit.
Some master units have (+)/(–) (volume)
buttons, and some have a dial.
This instructions shows as follow.
Rotate/press (+) or (–).

Note
There may be a difference between the display items of this
manual and the master unit.

Note in operation

• The unit has a digital volume control system.

Do not down the volume of the master unit
too much as doing so may cause the sound
quality to deteriorate.

• When you connect this unit to the master

unit, the loudness function will not work.

• The sound becomes unclear in some

situations (such as when the BAS, TRE or EQ
are excessively boosted).

• Two units can not be used at same time.

About operation mode

This unit has three operation modes.

Sound Control Mode

Select the item or adjust it partially.
• EQ (Graphic Equalizer): Select the equalizer

curve.

• POS (Listening Position): Select the listening

position.

• SUB (Subwoofer): Adjust the subwoofer

volume level.
Sound control mode can adjust not only BAS,
TRE, BAL, FAD but also VOL. For further
details, read the master unit instructions.

Sound Tuning Mode

Tune in the item selected in the Sound Control
Mode exactly.
• EQ (Graphic Equalizer): Setting and

registering the equalizer curve.

• POS (Listening Position): Adjust the

listening position.

• CNW (Cross Over Network): Adjust the cut-

off frequency.

Name Edit Mode

EQ (Graphic Equalizer): Naming the equalizer
curve.

DSP

Selecting the stored
equalizer curve

— Sound Control Mode

You can select the stored equalizer curve
(MEMORY1 to MEMORY9) or an unadjusted
curve (FLAT).

1

Press (SOURCE) to select a source (radio,
tape, CD or MD etc.).

2

Press (SOUND) repeatedly until “EQ”
appears.

3

Rotate/press (+) or (–) to select the
stored equalizer curve.

After three seconds, the display goes back
to the normal playback mode.

Tip
To adjust the stored equalizer curve further, press
(SOUND) for two seconds within three seconds after
following step 3 above. Then go to step 4 to 8 of “Setting
and storing the equalizer curve.”

Setting and storing the
equalizer curve

— Sound Tuning Mode

You can adjust the 21 band frequencies to
make an equalizer curve, and store up to nine
curves.

Front (18 band):

30 Hz, 45 Hz, 62 Hz, 90 Hz, 130 Hz, 190 Hz,
270 Hz, 400 Hz, 580 Hz, 840 Hz, 1.2 kHz,
1.7 kHz, 2.5 kHz, 3.6 kHz, 5.2 kHz, 7.5 kHz,
11 kHz, 16 kHz

Rear (3 band):

90 Hz, 840 Hz, 7.5 kHz

1

Press (SOURCE) to select a source (radio,
tape, CD or MD etc.).

2

Press (SOUND) for two seconds.

EQ

1 MEMORY1

SUR EQ

Advertising