Remote control operation, Plasmacluster ion mode selections – Sharp FP-N40CX Manuel d'utilisation

Page 15

Advertising
background image

ENGLISH

Plasmacluster

AUTO MANUAL

Fan Control

POLLEN

OFF

TIMER

DISPLAY

ON/OFF

POWER ON/OFF

FILTER RESET

CLEAN

ION CONTROL

OFF

AUTO

POWER ON/OFF Button

Used to start AUTO operation
of the unit. A short beep will
signal that the unit is on and
a long beep means that the
unit is off.

Auto (Fan Level) Button

The fan level switches auto-
matically depending on the
amount of impurities in the air.

Manual (Fan Level) Button

The fan level can be switched
between Silent, Medium,
High and Max.

Display ON/OFF Button

Switches the Plasmacluster
Indicator Light and CLEAN-
SIGN Light either ON or OFF.
• The Plasmacluster Indicator

Light is turned on for about
3 seconds by pressing the
Plasmacluster Ion Select
Button (except for the OFF
Button) during “Display
OFF” mode.

Plasmacluster Ion mode Selections

Auto

When pressed, the unit will switch between
Clean Mode and the Ion Control Mode auto-
matically depending on the amount of impuri-
ties in the air as detected by the odor sensor.
Clean Mode will operate for about 1 minute
when the Auto function is selected.

Ion Control

When pressed, the unit will constantly oper-
ate in Ion Control Mode.
Ion balance is maintained in the room envi-
ronment by increasing the ratio of negative
ions. (The Plasmacluster Indicator Light is
green)

Clean

When pressed, the unit will con-
stantly operate in the Clean Mode,
in which the same numbers of posi-
tive and negative ions are dis-
charged. (The Plasmacluster Indi-
cator Light is blue.)

Off

The generation of ions will cease
and the Plasmacluster Indicator
Light will go out.

If the room is damp or has a mold problem, operate the unit in Clean Mode.

Operations available with

the Remote Control

REMOTE CONTROL OPERATION

E-13

• When you press the POWER ON/OFF Button, a short

beep will sound and operation will start. As the initial
operation mode, it automatically goes to the AUTO (Fan
level) and AUTO Plasmacluster Ion Mode.

• To stop operation, press the POWER ON/OFF Button again.
A long beep will sound and operation will stop.

Transmitter

Filter Reset Button

When you have cleaned the
Washable Active Carbon Filter
and re-inserted into the main unit,
press the Filter Reset Button with
an instrument with a point such as
a pen.

Pollen Mode Operation Button

The unit operates effectively when
you suspect there is pollen in the
air. See Page E-12

Off Timer Button

Used to set the Off Timer.
The set time switches every time
the button is pressed as shown
below.

1 hour

4 hours

Cancel

8 hours

• The indicator light shows the re-

maining time.

• The unit will cease operating

when the timer is up.

• AUTO
• MANUAL
• POLLEN
• OFF TIMER
• DISPLAY ON/OFF

Plasmacluster Ion mode

selections

• AUTO
• CLEAN
• ION CONTROL
• OFF

Advertising