Jenn-Air W10253462A - Manuel (Page 15)

15
Style 2: Direct wire strain relief
■ Use Phillips screwdriver to remove screws from panel on
back of range.
■ Lift range back panel up and off.
■ Use Phillips screwdriver to remove screws and slide
cord/conduit plate down and out.
■ Position cord/conduit plate as shown in the following
illustration.
■ Replace cord/conduit plate and insert screws.
■ Assemble a UL listed conduit connector in the opening.
■ Feed the flexible conduit through the strain relief, allowing
enough slack to easily attach wiring to the terminal block.
■ Tighten strain relief screw against the flexible conduit.
5. Replace back panel and screws on rear of range.
6. Complete installation following instructions for your type of
electrical connection:
4-wire (recommended)
3-wire (if 4-wire is not available)
RE MO VE TA G! US E NU TS WIT H P OW ER CO RD NU TS WIT H P OW ER CO RD QU ITE LA ET IQU ETA US E L AS TU ER CA S PA RA CO NE CTA R E L CO RD ÓN EL ÉC TR ICO RE MO VE TA G! US E NU TS WIT H P OW ER CO RD QU ITE LA ET IQU ETA PA RA CO NE CTA R E L CO RD ÓN EL ÉC TR ICO
RE MO VE TA G! US E NU TS WIT H P OW ER CO RD NU TS WIT H P OW ER CO RD QU ITE LA ET IQU ETA US E L AS TU ER CA S PA RA CO NE CTA R E L CO RD ÓN EL ÉC TR ICO RE MO VE TA G! US E NU TS WIT H P OW ER CO RD QU ITE LA ET IQU ETA PA RA CO NE CTA R E L CO RD ÓN EL ÉC TR ICO
A. Removable retaining nut
B. Strain relief
A
B