Jenn-Air DUAL FUEL SLIDE-IN RANGE JDS8860 - Manuel (Page 26)

26
Oven Door
For normal range use, it is not suggested to remove the oven
door. However, if removal is necessary, make sure the oven is off
and cool. Then, follow these instructions. The oven door is heavy.
To Remove:
1. Open oven door to the first stop position (opened about
4" [10.0 cm]).
2. Grasp door at each side. Do not use the door handle to lift
door.
3. Lift up evenly until door clears hinge arms.
To Replace:
1. Grasp door at each side.
2. Align slots in the door with the hinge arms on the range.
3. Slide the door down onto the hinge arms until the door is
completely seated on the hinges. Push down on the top
corners of the door to completely seat door on hinges. Door
should not appear crooked.
TROUBLESHOOTING
Try the solutions suggested here first in order to avoid the cost of an unnecessary service call.
Nothing will operate
■ Household fuse blown or circuit breaker tripped?
Replace the fuse or reset the circuit breaker. If the problem
continues, call an electrician.
■ Is the main or regulator gas shutoff valve in the off
position?
See Installation Instructions.
■ Is the range properly connected to the gas supply?
Contact a trained repair specialist or see Installation
Instructions.
Surface burners will not operate
■ Is this the first time the surface burners have been used?
Turn on any one of the surface burner knobs to release air
from the gas lines.
■ Is the control knob set correctly?
Push in knob before turning to a setting.
■ Are the burner ports clogged?
See “Sealed Surface Burners” section.
Surface burner flames are uneven, yellow and/or noisy
■ Are the burner ports clogged?
See “Sealed Surface Burners” section.
■ Are the burner caps positioned properly?
See “Sealed Surface Burners” section.
■ Is propane gas being used?
The range may have been converted improperly. Contact a
service technician or see “Assistance or Service” section.
Surface burner makes popping noises
■ Is the burner wet?
Let it dry.
Excessive heat around cookware on cooktop
■ Is the cookware the proper size?
Use cookware about the same size as the surface cooking
area, element or surface burner. Cookware should not extend
more than ½" (1.3 cm) outside the cooking area.
Cooktop cooking results not what expected
■ Is the proper cookware being used?
See “Cookware” section.
■ Is the control knob set to the proper heat level?
See “Cooktop Controls” section.
■ Is the range level?
Level the range. See the Installation Instructions.
Oven will not operate
■ Is the electronic oven control set correctly? See
“Electronic Oven Control” section.
■ Has a delay start been set? See “More Options” section.
■ On some models, is the Control Lock set? See “Locking
the Oven Control and Oven Door” section.
■ On some models, is the Sabbath Mode set? See “Sabbath
Mode” in the “Setup” section.
Oven temperature too high or too low
■ Does the oven temperature calibration need adjustment?
See “Temp Adjust” in the “Setup” section.
Display shows messages
■ Is the display showing “FAULT DETECTED?” A fault has
been detected. Follow the displayed directions “PRESS
ENTER TO TRY AGAIN” or “DISABLE POWER TO CLEAR.” If
the fault does not clear, reappears, or “FEATURE NOT
AVAILABLE” is displayed, call for assistance or service.
■ Is “SAb” flashing?
Oven is in Sabbath Mode. To cancel, press and hold the
SETUP pad for 5 seconds.