John Deere TY25864 - Manuel (Page 25)

Controls and Operation
OUOD006,0000019 –19–16JUN04–4/4
NOTE: When display indicates 77% charged, battery is
charged well enough to start most vehicles.
NOTE: When charging is completed, the CHARGE
(green) LED illuminates and the battery charger
switches to the Maintain Mode, or Float Mode, of
operation. In this mode, the battery charger
delivers a small current when necessary to keep
the battery fully charged.
If charging can’t be completed normally, the
charger’s output is shut off and the red CHECK
LED and the digital display blink on and off. In this
aborted state, the charger ignores all buttons. To
reset after aborted charge, either disconnect the
battery or unplug the charger.
9. To disconnect the battery charger after charging, first
unplug the power cord. Then remove the clamp from
the jumper cable attached to the NEGATIVE battery
post, and finally, disconnect the clamp from the
POSITIVE battery post.
10. Clean and store the battery charger in a dry location.
10-14
091604
PN=25