John Deere HR-2700GH - Manuel (Page 27)

AC-Series Operator’s Manual-E/F 7
a
Service
gasOline engine Oil
Use oil viscosity based on the expected air temperature
range during the period between oil changes.
John Deere TURF-GARD
TM is preferred. Also
recommended is John Deere PLUS-4 ® .
Other oils may be used if they meet one or more of the
following:
•API Service Classification SH
•API Service Classification SG
•CCMC Specification G4
•CCMC Specification G5
Changing engine Oil
IMPORTANT: Change oil after first 20 hours of operation
and every 100 hours thereafter.
. Put unit on level surface.
. Run engine a few minutes to warm oil.
. Stop engine.
4. Remove oil filler cap (A) and drain plug (C) and drain oil into
container. Do not pollute, dispose of waste oil properly.
5. Install drain plug (C). Fill with oil to top of threads. Install
cap. Oil capacity is :
-HR-500GH AND HR-700GH: 0.6L (0.6 qts.)
DWG
-
0
99
R
0
-40°f
-22°f
-4°f
14°f
32°f
50°f
68°f
86°f
104°f
122°f 50°C
40°C
30°C
20°C
10°C
0°C
-10°C
-20°C
-30°C
-40°C
sae 10W
-40
sae 10W
-30
sae 5W
-30
CheCk engine Oil
NOTE: All washers are shipped with engine oil. Check
proper level.
. Stop engine.
. Place unit on level surface.
3. Remove oil filler cap/dipstick and wipe it clean.
4. Insert filler cap/dipstick into oil filler neck, but DO NOT
screw it in.
5. Remove dipstick. Proper oil level is at midpoint of
dipstick (A). Add oil if necessary to bring oil level to
top of threads (B).
6. Install and tighten cap.
PIC
0-
0

99
R
0
P
05-0

07
b
C