Jensen JDV8035 - Manuel (Page 8)

JDV8035
8
DETACHABLE CONTROL PANEL
• DO NOT insert the control panel from the
left side. Doing so may damage it.
• Do not put pressure on the display or
control buttons when handling the front
panel.
• The rear connector that connects the main
unit and the D.C.P is an extremely
important part. Be careful not to damage it
by pressing on it with fingernails, pens,
screwdrivers, etc.
• If the D.C.P becomes dirty, wipe with a soft,
dry cloth only. Use a cotton swab soaked in
isopropyl alcohol to clean the socket on the
back of the D.C.P.
• Make sure there is no dust or dirt on the
electrical terminals on the back of the panel
as this could cause intermittent operation or
other malfunctions.
• The D.C.P can easily be damaged if
dropped. After removing it, place it in a
protective case and be careful not to drop it
or subject it to strong shocks.
• When the release button is pressed and the
D.C.P is unlocked, the car's vibrations may
cause it to fall. To prevent damage to the
D.C.P, always store it in a protective case
after detaching it.
Removing the Control Panel
The front panel release button (3) releases the
mechanism that holds the front panel to the
chassis. To detach the front panel, perform the
following steps:
1. Turn the power off.
2. Press the release button.
3. Grasp the left side to release the front panel
and then pull it an an angle to remove the
right side from the chassis.
Attaching the Control Panel
Before re-attaching the front panel, make sure
the electrical terminals on the back of the panel
are free of dust and dirt, as debris could cause
intermittent operation or other malfunctions.
To attach the front panel:
1. Insert the right side of the control panel into
the main unit, making sure the panel is
attached at the T-joint (see diagram).
2. Push the left side of the control panel near
the middle until a “click” sound is heard.
Release
Button
Control Panel
2.
1.
PUSH