Jensen JDV8035 - Manuel (Page 5)

JDV8035
5
vided. Bend the strap, as necessary, to
position it. CAUTION: The rear of the radio
must be supported with the strap to prevent
damage to the dashboard from the weight
of the radio or improper operation due to
vibration.
9. Test radio operation by referring to the
operating instructions for the unit.
Trim Plate Installation
Push the trim plate against the chassis until it is
fitted. You must do this before you install the
control panel, otherwise it can't be attached.
Removing the Unit
To remove the radio after installation:
1. Insert fingers into the groove on the front of
the frame and pull out to remove the frame
(when re-attaching, point the edge with the
groove downward and attach).
2. Insert the removal keys straight back until
they click, and then pull the radio out. If
removal keys are inserted at an angle, they
will not lock properly to release the unit.
Dashboard
Plain Washer
Screw ( 4 x 12mm)
Hex Nut (5mm)
Spring Washer
Screw Stud
Support Strap
Dashboard
Removal Key