Jacuzzi AIR BATHS LUXURY SERIES - Manuel (Page 14)

Jacuzzi © Whirlpool Bath: Installation and Operation Page 1 BE76000F • December 2007
ENGLISH
MAINtENANCE
hEAtED AIR BAth DRYINg CYCLE
The Heated Drying Cycle feature is an integral part of and
required to complete the draining process of the Jacuzzi © Luxury
Air Bath air channel system. While the bathtub is being drained,
after normal use, dual water sensors monitor the water level.
The sensors are located near the tub drain. Once the dual water
sensors detect a “No Water” condition this specially designed
system will activate a 5 minute wait timer before activating the
blower. This action is indicated on the control panel by a slow
flashing LED near the blower oN/oFF button. If the unit has not
been used during this 5 minute wait and the sensors have not
detected water, the blower will automatically come on at various
speeds over a 2-1/2 minute duration. The duration and speed of
the blower are exclusively matched for Jacuzzi © Luxury Air Bath
products and are programmed to effectively reduce excessive
accumulation of remaining bath water in the air plumbing.
If at any time during the Drying Cycle, the control panel is
operated by the User, or a system power recycle has occurred,
the 5 minute timer will re-initialize and the above sequence will
repeat to ensure the completion of the Drying Cycle.
NOtE: The Drying Cycle will activate on first power-up of the
unit.
PROgRAM thE 24-hOUR DRYINg CYCLE
A 24-hour drying cycle can be programmed to come on at the
same time every day. To activate this feature, hold the Up Arrow
button for five seconds when the blower-heater is off or while
waiting for the normal cycle to occur.
The Indicator will flash twice. (If the unit is in the Standby mode
for the normal cycle when activating the 24-hour cycle, the
normal cycle will be cancelled.)
When the 24-hour cycle is activated, the Indicator will flash
continuously (at a slower rate than during normal cycle). The
cycle will then come on at the same time every day. To cancel
the 24-hour cycle, press the up Arrow button and the Indicator
will stop flashing.