Miller Electric Big 40 WG - Manuel (Page 44)

OM-4405 Page 40
3 1
8-8. Servicing Fuel And Lubrication Systems
802 731 / Ref. 801 434
Y Stop engine and let cool.
Y After servicing, start engine and
check for fuel leaks. Stop engine,
tighten connections as necessary,
and wipe up spilled fuel.
1 Oil Filter
2 Oil Drain Valve And Hose
3 Oil Fill Cap/Dipstick
4 Fuel Tank Sludge Drain Valve
To change oil and filter:
Route oil drain valve and hose through hole
in base. See engine manual and engine
maintenance label for oil/filter change in-
formation.
To drain sludge from fuel tank:
Y Beware of fire. Do not smoke and
keep sparks and flames away from
drained fuel. Dispose of drained fuel
in an environmentally-safe manner.
Do not leave unit unattended while
draining fuel tank.
Y Properly lift unit and secure in a level
position. Use adequate blocks or
stands to support unit while drain-
ing fuel tank.
Attach 1/2 ID hose to drain valve. Put metal
container under drain, and use screwdriver
to open sludge drain valve. Close valve
when sludge has drained. Remove hose.
Close door.
To replace fuel filter:
5 Fuel Line
6 Fuel Filter
Remove clamps and filter. Install new filter
and clamps. Inspect fuel lines and replace
if cracked or worn. Wipe up any spilled fuel.
Start engine and check for leaks.
Y Stop engine, tighten connections as
necessary, and wipe up spilled fuel.
Close door.
Tools Needed:
4
2
6 5