Maytag W10295008A - Manuel (Page 13)

13
■ You will hear the door locking, unlocking, and locking
again. This is normal.
■ If you do not press START/PAUSE within 5 minutes of
choosing a cycle, the washer automatically shuts off.
■ When the wash cycle is complete, the DONE status light
illuminates, the door unlocks, and the wash load can be
removed from the washer. The washer powers down
automatically 5 minutes after the cycle is complete and the
DONE light goes off until door is opened. To power down
the washer manually after the wash cycle is complete, press
POWER/CANCEL once.
8. To begin the wash cycle later
Press DELAY START until the desired delay time (in hours) is
displayed. Press START/PAUSE. The indicator will remain
illuminated during the desired time selected.
IMPORTANT: When delaying a cycle, use only powdered
detergents in the main wash compartment since liquid
detergents may seep out of the compartment during Delay,
before the wash cycle begins.
Using the Dispenser
Your new washer has a dispenser drawer with three separate
compartments for your laundry products—detergent, liquid chlorine
bleach, and liquid fabric softener. Laundry products are diluted and
dispensed automatically at the proper time during the wash cycle,
making it unnecessary for you to return to the washer during the
cycle to add them.
It is normal for small amounts of water to remain in the dispensers
when the wash cycle is complete.
Do not put laundry products directly into the wash tub. Always use
the proper dispensers when adding laundry products.
Choosing the Right Detergent
Use only High Efficiency detergents. The package for this type of
detergent will be marked “HE” or “High Efficiency.” This wash
system, along with less water, will create too much sudsing with a
regular non-HE detergent. Using regular detergent will likely result in
washer errors, longer cycle times, and reduced rinsing performance. It
may also result in component failures and noticeable mold or mildew.
HE detergents are made to produce the right amount of suds for the
best performance. Follow the manufacturer's instructions to
determine the amount of detergent to use.
Use only HE High Efficiency detergent.
To fill dispenser compartments
1. Pull out the dispenser drawer.
2. Add the desired laundry products to the proper compartment.
3. Push in the dispenser drawer slowly and completely (to avoid a
spill).
A
B
C
D
Dispenser
A. Dispenser release lever
B. Main Wash detergent compartment
C. Liquid chlorine bleach compartment
D. Fabric softener compartment
Main Wash detergent compartment
(Letter B in Dispenser Illustration)
Add liquid or powdered HE detergent to this compartment for your
main wash cycle.
■ Liquid color-safe bleach or oxi products may be added to the
Main Wash compartment along with liquid detergent.
■ Powdered color-safe bleach or oxi products may be added to the
Main Wash compartment along with the powdered detergent.
■ Do not mix powdered and liquid products in the Main Wash
compartment.
■ Use the measurement device which comes with the detergent.
Add no more than the manufacturer's recommended amount.
NOTE: Overfilling could cause an oversudsing condition.
Chlorine bleach compartment
(Letter C in Dispenser Illustration)
Add NO MORE THAN 2/3 cup (160 mL) liquid chlorine bleach to
this compartment. The bleach will be automatically diluted and
dispensed at the best time during the first rinse after the wash cycle.
This compartment cannot dilute powdered bleach.
■ Use only liquid chlorine bleach in this dispenser. Do not use this
dispenser to add powdered chlorine or any form of color-safe
bleach or oxi products to your load.
■ Always measure liquid chlorine bleach. Use a measuring cup
with a pour spout; do not guess. Follow the manufacturer’s
directions for proper use.
■ Do not fill beyond the “MAX” level.
NOTE: Overfilling could cause garment damage.
Fabric softener compartment
(Letter D in Dispenser Illustration)
Follow the manufacturer's instructions to determine the amount of
fabric softener to use. Fabric softener will be automatically
dispensed in the final rinse or in the 2nd Rinse, if selected.
■ Do not fill beyond the “MAX” level.
Pausing or Restarting
1. To pause the washer at any time, press START/PAUSE.
2. To continue the cycle, press and hold START/PAUSE (for
approximately 1 second).