Problem solver, Problem solver –23, Before you call for service – GE Monogram ZBD5600 Manuel d'utilisation

Page 20: Questions? use this problem solver

Advertising
background image

20

Before You Call For Service

Dishwasher

Questions?
Use this
problem
solver

PROBLEM

POSSIBLE CAUSE

WHAT TO DO

Cycle Status Indicators

Time too long between

Each button must be touched within

(on some models) go

button selection

15 seconds after touching another control.

off when you’re setting

Unusual noises

Some of the sounds you
will hear are normal

Timer advancing as cycle progresses.

Detergent cup opening.

Water draining out of the tub immediately
after you touch a button.

Utensils are not secure

Make sure everything is secured in

in the rack or something

dishwasher.

small has dropped into
the rack

Detergent left in

Dishes are blocking the

Reposition the dishes.

dispenser cups

detergent cups

Water won’t pump

Drain is clogged

If you have an air gap, clean it.

out of the tub

Check to see if your kitchen sink is draining

well. If not, you may need a plumber.

If the dishwasher drains into a disposer,

run disposer clear.

Suds in the tub

Correct detergent

Use only automatic dishwasher detergents

wasn’t used

to avoid sudsing.

To remove suds from the tub, open the

dishwasher and let suds evaporate. Add
1 gallon of cold water to the tub. Close the
door until it locks into place. On models
ZBD5700 and ZBD5900, pump out water
by pressing the NORMAL WASH button.
Wait one minute and press NORMAL
WASH again, then press CLEAR. Repeat if
necessary. On model ZBD5600, turn the
Cycle Selection dial to NORMAL WASH.
Wait one minute. Allow water to pump out.
Repeat if necessary.

Too much rinse

See the Rinse Agent section.

agent used

Dishes and flatware

Inlet water temperature

Raise the water heater temperature to 120°F.

not clean

is below 120°F.

Depending on model, use WATER TEMP

BOOST or WATER TEMP SANI option.

Water pressure is

Turn on a faucet. Is water coming out more

temporarily low

slowly than usual? If so, wait until pressure is
normal before using your dishwasher.

Air gap is clogged

Clean the air gap.

Improper rack loading

Make sure large dishware does not block

the detergent dispenser or the wash arm.

Advertising