GE Monogram ZBD5600 - Manuel (Page 18)

18
Care and Cleaning
Dishwasher
Light Bulb
Replacement
(on some
models) The interior light bulb is located in the rear top right
corner.
To replace—
1. Make sure the dishwasher is disconnected from the
power supply.
2. Unscrew the plastic lens counterclockwise.
3. Remove the bulb and replace with a maximum 15 watt
bayonet bulb no larger than 1
″
in diameter and 2
″
long. Order part # WD21X10055.
4. Make sure the seal is correctly fitted to the plastic lens
and screw it firmly into place.
CAUTION: The plastic lens must be secured before
reconnecting power to the dishwasher.
ATTENTION : Il faut remettre la lentille de plastique
en place avant de rétablir le courant au lave-vaisselle.
Water fill
level For best performance, check the water fill level of your
dishwasher.
Once the dishwasher is fully connected, run it through a
complete RINSE & HOLD cycle to ensure it is emptying
and filling correctly. For low water pressure situations run
the RINSE & HOLD cycle 3 times. Half way through the
final RINSE & HOLD cycle, pause the dishwasher and
check the water level inside the dishwasher. If the water
level is not above the minimum water level (marked on the
lower spray support tower), increase the fill level.
For Model ZBD5600—Remove the front kickplate and
change the Fill Time switch setting.
For Model ZBD5700 and ZBD5900—
1. Ensure the dishwasher is not running through a cycle.
Depress the WATER TEMP button for ten seconds
until the second buzzer sounds.
2. Press the CLEAR button to select fill time, as per chart
(80 seconds is the factory setting).
3. To test time, press DELAY START. The dishwasher
will start filling. Listen for the dishwasher to complete
filling. Once filled, the fill level must be checked to
ensure fill time is correct.
4. Once complete, press the WATER TEMP button to
exit fill time mode.
Maximum level
Minimum level
Plastic lens
Light bulb
Unscrew lens in a
counterclockwise
direction
Fill time switch
Cycle Status
Indicators Fill time
PRE-WASH 75 seconds
WASH 80 seconds
RINSE 90 seconds
DRY 100 seconds
CLEAN 110 seconds
Continue to press the
CLEAR button until the desired
indicator is illuminated.