Elmo TT-02S - Manuel (Page 32)

32
English
OPERA
TION
PR
OCEDURE
Presentation using a Microscope
Adjust
Adjust
Setting a microscope
Place an object such as a prepared slide on a microscope. Adjust focus by checking with
eyes at the microscope side.
Setting the main unit
Connect the main unit to a projector or a PC monitor. Then turn the power switch of the
main unit ON.
Changing to the Microscope mode
Change the Microscope mode to [Set] from the OSD menu. Then connect the main unit to
a microscope as shown in the above figure.
Adjusting the focus
Adjust the focus on the microscope. At this time, please take care to ensure that the eyepiece does not come
into contact with the lens of the main unit, and that the objective lens does not damage the prepared slide.
Adjusting the brightness
Press the [BRIGHTNESS • ] and [BRIGHTNESS • ] buttons on the main unit to
adjust the image brightness. P.39
Note
• Pay attention to prevent the lens from knocking on a microscope.
• When being changed to the microscope mode, [Graphics] is automatically selected as [Mode].
Note
• When using the document camera successively after the use of microscope, set [Set]
→ [Off] in the OSD.
• When setting [Set] → [Off] in the OSD, [Mode] gets back to the selected [Mode] just
before being changed to the microscope mode.