Chap 4-installing and removing drives, Installing and removing drives, Chapter 4 – Epson ActionTower 3000 Computer Manuel d'utilisation

Page 71

Advertising
background image

Chapter 4

Installing and Removing Drives

This chapter describes how to install and remove optional

drives in your computer. You can use these instructions to

install a variety of devices, including hard disk, diskette, tape,

CD-ROM, and optical drives. Although your drive may look

different from the ones illustrated here, you should be able to

install it the same way.

Your computer can hold up to seven mass storage devices, as

described in the table below.

Drive bay

Drive type and size

Four externally accessible

bays

Two 5,25-inch, half-height drives or

one 525-inch. full-height drive

and two 3 S-inch, half-height drives

One front internal bay One 3,5-inch. half-height or third-height

drive

Two rear internal bays Two 3.5-inch, half-height or third-height, or

one 3.5-inch, full-height drive

Note

The main system board in your computer supports up to

two diskette drives (or one diskette drive and one tape

drive) and up to two IDE hard disk drives. If you install

more than four drives, you must install a drive controller on

an option card, such as a SCSI controller card, for the

additional drive(s).

Installing and Removing Drives 4-1

Advertising