Epson ActionTower 3000 Computer - Manuel (Page 55)

Inserting SIMMs
Follow these steps to install SIMMs:
1. Refer to the illustration on page 3-5 to locate the SIMM
sockets.
2. Turn the computer around so the back panel is facing you.
3. Remove the four screws securing the rear internal drive bay
bracket to the computer’s back panel. Then slide the
bracket out of the computer and set it aside for now.
4. Rest the computer on its side, so that the system board is flat
and the components are easy to reach.
5. Position the first SIMM at an angle over the first empty
socket in the bank you are filling, as shown in the next
illustration. The components on the SIMM should face the
power supply.
3-12 Installing and Removing Options