Epson ActionTower 3000 Computer - Manuel (Page 36)

Exiting SETUP
When you leave SETUP, you can save your settings, or exit
SETUP without saving your settings. You can also return all
values to the factory defaults.
To leave SETUP, press E
SC
from any SETUP screen. From the
Main Menu, you can do the following:
Load ROM
Default Values
Loads the factory default settings
stored in ROM back into CMOS.
If you change your system
configuration and then have
problems, you can load the ROM
values to boot the system and start
over.
Load Values
from CMOS
Loads the current values stored in
CMOS for all SETUP options. This
ignores any changes you have
made using SETUP.
Save Values
Saves the configuration changes
to CMOS you have made to CMOS.
Post-SETUP Procedures
After you run SETUP for the first time, you may need to install
the operating system if your computer is not preconfigured.
See your operating system manual for instructions.
Once you have installed your operating system, install any
software you plan to use. See your application program
manuals for instructions.
1-20 Setting Up Your System