Curtis RPW091 - Manuel (Page 8)

12 13
Special features Special features
Fuzzy control function
Power failure memory function
Under the “fuzzy” program,the machine automatically detect amount of laundry, and then select
water level automatically. If water exists in the tub when starting operation, the machine cancel
“fuzzy” control .If users choose water level before starting operation .the machine cancel “fuzzy
control” function
If the power supply becomes off suddenly during operation ,the machine remembers the current
operation state, when power is on, the machine returns to former operation state automatically
Only for washers having these two functions
Use the cleaning solution for twice
1. Put the laundry in the first batch and wash powder and press ”
button to set single “wash” to run.
wash
2. Take out the laundry in the first batch after hearing the buzzing sound.
3. put in the laundry in the second batch, and run “ Wash”、 “Rinse”、“Spin”.
4. Take out the laundry in the second batch after hearing the buzzing sound.
5. Put in the laundry in the first batch
and press button
to run “ Wash”、 “Rinse”and “Spin”
“ Wash”、 “Rinse”、“Spin”
Washing tips
Weight standard of clothes
Union suit including coat and
trousers(blended) about 800g Pyjamas including coat and
trousers (cotton) about 500g Long sleeves shirt
(blended) about 200g Short sleeves shirt
(cotton) about 130g
Bed sheet (cotton)
about 500g Bath towel (cotton)
about 300g Trunks (cotton)
about 50g Socks (blended)
about 50g
1.Put the easily damaged and loose clothes into mesh before washing.
2.Put bulk clothes and easily suspended clothes at the bottom of tub.
3.Turn over the easily damaged face of clothes before washing.
4.If the clothes hold webbing and zipper, you need to tie and zipper that before washing.
5.Get rid of mud on clothes before washing.
6.You can add some washing powder on the specially dirty place before washing.
1. If the machine do not start to work within 10 minutes after powered on, it will power off
automatically.
2.After end of operation and the buzzer sounding 6 times, it will power off automatically.
1.If the laundry is placed uneven before spinning, it is likely to cause vibration during spinning. The
washing machine has a function of adjusting unbalance . When working, the washing machine
always inspects operation state automatically. If the spinning vibration is too great, the washing
machine automatically starts the adjusting program to balance.
2. If the washing machine can adjust the unbalance twice. If the adjustment has no function, it will alarm.
Function of automatic power shut off
Function of adjusting for unbalance
Soak wash
1. Switch on the power. Open the tap and lay the drain hose.
2. Put in clothes and detergent.
3. Select proper
according to the weight of clothes.
4. Press the
5. Press Start/Pause button and close the lid.
Load Size
button, the lights of Soak will turn on. “program" " "
" "
1.Press the select program” button, the indicator light will move in turn ,and corresponding choose
“
”、“Gentle”、 “Normal 、 Rapid” “Soak”.
2.If select the “ ”program. you can Select “washing、 rinsing、 spin” ; “wash”; “wash、rinse”;
“washing、spin”;“Spin” Various combinations, according to different needs, choose different by
yourselves.
“
Heavy
Heavy
” “
Notices:
The appliance is not intended for use by persons (including children) with reduced physical,
been sensory or mental capabilities, or lack of experience and knowledge, unless they have
given supervision or instruction concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
If the supply cord is damaged, it must be replaced by the manufacture, its service agent or
similarly qualified persons in order to avoid a hazard.
appliance with ventilation openings in the base, that a carpet must not obstruct the openings)
the new hose-sets supplied with the appliance are to be used and that old
should hose-sets
not be reused
Pre-wash of dirty clothes
As for seriously stained clothes , can select “ rinse” , “Spin” program to
perform pre-wash and then add detergent to select other programs to wash.
1. Do not use water above 65°C to prevent plastic deformation.
2. If the actual water level does not reach the set water level during operation, the
washing machine will inject water automatically.