Curtis TVD1400A - Manuel (Page 3)

CLASS 1
LASER PRODUCT
AUTOMATIC DEGAUSSING
All colour television receivers are sensitive to magnetic influences, usually
caused by either moving the receiver from one place to another or using certain
electrical appliances near the receiver. This residual magnetism as it is called,
sometimes causes distortion which gives rise to "blotchy" areas of colour in the
picture. To avoid these effects the receiver incorporates
an automatic degaussing circuit which operates for a short while immediately each
time the receiver is switched on using the mains switch. This circuit removes any
residual magnetism in the metal parts of the picture tube and therefore ensures that
each time the receiver is switched "ON" using the Mains switch, the purity of the
colours displayed on the screen remain true and lifelike. If the set is moved or
faced in a different direction , the mains switch must be switched off at least 10
minutes in order that the automatic degaussing circuit operates properly.
CAUTION
Never replace with any components inside your set, or any other adjustment
controls not mentioned in this manual. All television receivers are high voltage
instruments. Your PICTURE TUBE is highly evacuated. If broken, glass fragments
will be violently expelled. Scratching, shipping or undue pressure is dangerous and
should be avoided. When you dust or wipe the PICTURE TUBE FACE or CABINET,
the power plug should be pulled out from the socket , then wipe the receiver with a
dry soft cloth. All "inside work" on your receiver should be performed only by
Professional Service Personnel.
IMPORTANT
The DVD section of this TV DVDcombo requires several seconds to
configure itself immediately after switch on During this period the TV screen
will comain in blank this is not a fault with your set
We recommends you DO
NOT press any buttons on the remote control or TV set while this
configuration is process
/
.
LASER SAFETY
This unit employs an optical laser beam system
in the CD mechanism, designed with built in
safeguards. Do not attempt to disassemble, refer to
qualified service personnel. Exposure to this invisible
laser light light beam may be harmful to the human
eye.
THIS IS A CLASS-1 LASER PRODUCT. USE OF
CONTROLS, OR ADJUSTMENTS OR PROCEDURES
OTHER THAN THOSE SPECIFIED HEREIN, MAY
RESULT IN HAZARDOUS LASER LIGHT BEAM
Invisible laser radiation when open
and interlock failed or defeated.
avoid direct exposure to laser beam.
DANGER
Front of the machine
Installation
8 11
9 10
13
14 12
7
2 4 3 5 6 1
17
VIDEO
AUDIO
IN PUT
L
R
POWER
16
COAXIAL
15
1. TV/AV/DVD button
Pressing this button can switchover as
follows:
TV VIDEO1 VIDEO2 DVD
2. MENU
3. Channel Button(CH-)
4. Channel Button(CH+)
5. Volume Button(VOL-)
6. Volume Button(VOL+)
7 Main power switch
8. Speaker
9. Open close button
10. SKIP
11. Remote control receiving window
12. Indicator
13. SKIP
14
Play pause button
15.
16. Side AV
17. 75 ohm Antenna Socket
18. Side AV
interface description:
1
Side AV: AV1 signal input in VIDEO1
mode.
2
Rear AV: AV2 signal input in VIDEO2
mode.
.
/
. /
．
．
-
+
Note:
Because the Audio inputs of DVD and rear
AV
are parallel , so when using DVD,
please don't input signal to rear AV at the
same time.
COAXIAL
GB-2 GB-3