Eagle Electronics CUDA 300 - Manuel (Page 20)

14
Power connections for the Cuda 300 sonar unit
(direct battery connection shown).
For example, if you have to extend the power cable to the battery or
power buss, attach one end of the fuse holder directly to the battery or
power buss. This will protect both the unit and the power cable in the
event of a short. It uses a 3-amp fuse.
Caution:
Do not use this product without a 3-amp fuse wired into the
power cable! Failure to use a 3-amp fuse will void your war-
ranty.
This unit has reverse polarity protection. No damage will occur if the
power wires are reversed. However, the unit will not work until the
wires are attached correctly.
Mounting the Sonar Unit: In-Dash, Bracket or Portable
You can install the sonar unit on the top of a dash with the supplied
bracket. This unit can be installed in a dash with the optional FM-6 in-
dash adapter kit. The FM-6 kit includes an instruction sheet, part 988-
0147-631, which contains a template for cutting out the mounting hole.
This document can be downloaded free from the www.eaglesonar.com
web site.
12 volt
battery
Black wire
Red wire with
3 amp fuse
To unit