Eagle Electronics CUDA 300 Manuel d'utilisation

Page 14

Advertising
background image

8

Assemble transducer and bracket.

B. Two-piece bracket: Once you determine the correct position for

the ratchets, assemble the transducer as shown in the figure in step

2B. Don't tighten the lock nut at this time.

Assemble transducer and bracket.

4. Drilling mounting holes.

Hold the transducer and bracket assembly against the transom. The

transducer should be roughly parallel to the ground. The trans-

ducer's centerline should be in line with the bottom of the hull. Don't

let the bracket extend below the hull!

Nut

Metal
washer

Metal washer

Bolt

Rubber
washers

Flat washer

Lock washer

Flat washer

Nut

Bolt

Advertising