Maytag MET3800XW - Manuel (Page 15)

15
WINTER STORAGE CARE
IMPORTANT: To avoid damage, install and store washer/dryer
where it will not freeze. Because some water may stay in
hoses, freezing can damage washer/dryer. If storing or moving
during freezing weather, winterize your washer/dryer.
To winterize washer/dryer:
1. Shut off both water faucets, disconnect and drain water inlet
hoses.
2. Put 1 qt. (1 L) of R.V. - type antifreeze in basket and run
washer on RINSE cycle for about 30 seconds to mix
antifreeze and remaining water.
3. Unplug washer/dryer or disconnect power.
VACATION, STORAGE, AND MOVING CARE (cont.)
For washers:
1. Shut off both water faucets. Disconnect and drain water inlet
hoses.
2. If washer/dryer will be moved during freezing weather,
follow “Winter Storage Care” directions before moving.
3. Disconnect drain from drain system and drain any
remaining water into a pan or bucket. Disconnect drain hose
from back of washer.
4. Place inlet hoses and drain hose inside washer basket.
5. Drape power cord over edge and into washer basket.
6. Place packing tray from original shipping materials back inside
washer/dryer. If you do not have packing tray, place heavy
blankets or towels into basket opening. Close doors and place
tape over doors and down front of washer/dryer. Keep doors
taped until washer/dryer is placed in new location.
REINSTALLING/USING WASHER/DRYER
To reinstall washer/dryer after non-use, vacation, moving
or winter storage:
1. Refer to Installation Instructions to locate, level, and
connect washer/dryer.
2. Before using again, run washer/dryer through the following
recommended procedure:
To use washer/dryer again:
1. Flush water pipes and hoses. Reconnect water inlet hoses.
Turn on both water faucets.
(continued in next column)
2. Plug in washer/dryer or reconnect power.
3. Run washer through a complete cycle to clean washer
and remove antifreeze, if used. Use half the manufacturer’s
recommended amount of detergent for a medium-size load.
In the U.S.A.
In Canada