Washer/dryer maintenance – Maytag MET3800XW Manuel d'utilisation

Page 12

Advertising
background image

12

5.

Press PUSH TO START to

begin cycle

Push and hold the PUSH TO START knob to begin the cycle.
Promptly remove garments after cycle has completed to reduce

wrinkling. Use the Wrinkle Prevent feature to avoid wrinkling when

you are unable to remove a load from the dryer as soon as it stops.

4.

Select End of Cycle signal

(optional)

Your dryer may have an End of Cycle signal. The signal is helpful

when drying items that should be removed from the dryer as

soon as it stops. The End of Cycle signal is part of the PUSH

TO START button and is selectable. Turn the PUSH TO START

button to ON or OFF. The signal will sound only if the selector is

set to ON.
NOTE: When the Wrinkle Prevent setting is selected and the

End of Cycle signal is on, the tone will sound every 5 minutes

until the clothes are removed or the Wrinkle Prevent setting ends.

Replace inlet hoses after 5 years of use to reduce the risk of

hose failure. Periodically inspect and replace inlet hoses if

bulges, kinks, cuts, wear, or leaks are found.
When replacing your inlet hoses, mark the date of replacement

on the label with a permanent marker.

WATER INLET HOSES

WASHER/DRYER MAINTENANCE

WASHER CARE

Recommendations to Help Keep Your Washer

Clean and Performing at its Best

1. Always follow the detergent manufacturer’s instructions

regarding the amount of detergent to use. Never use more

than the recommended amount because that may increase

the rate at which detergent and soil residue accumulate inside

your washer, which in turn may result in undesirable odor.

2. Use warm and hot wash water settings sometimes (not

exclusively cold water washes), because they do a better job

of controlling the rate at which soils and detergent

accumulate.

3. Always leave the washer lid open between uses to help dry

out the washer and prevent the buildup of odor-causing

residue.

Cleaning Your Top Loading Washer

Read these instructions completely before beginning the

routine cleaning processes recommended below. This Washer

Maintenance Procedure should be performed, at a minimum,

once per month or every 30 wash cycles, whichever occurs

sooner, to control the rate at which soils and detergent may

otherwise accumulate in your washer. To keep washer interior

odor-free, follow this recommended monthly cleaning procedure:
affresh

®

Washer Cleaner Cycle Procedure (Recommended

for Best Performance):

a. Open the washer lid and remove any clothing or items.
b. Place an affesh

®

Washer Cleaner tablet in the bottom of

the washer basket.

c. Do not add any detergent or other chemical to the washer

when following this procedure.

d. Close the washer lid.
e. Select Normal Heavy cycle, Hot Temperature, and High

Water Level.

f. Pull out the Cycle knob. Water will pour into washer for

a moment and then pause; the lid will lock and the cycle

will continue.

NOTE: For best results, do not interrupt cycle. If cycle must

be interrupted, push in the Cycle knob.

Advertising