Danby DPAC 13009 - Manuel (Page 11)

The AUTO-TIMER feature offers a unique selection of multiple choice,
fully automatic on and/or off (start/stop) programs between 1-12 hrs
under any one mode of your Home Comfort Unit.
The programs are as follows:
a) Auto-Off: Pre-select a time that will turn off the unit automatically (between 1-12hrs).
b) Auto-On: Pre-select a time that will turn on the unit automatically (between 1-12hrs).
c) Auto-On & Auto Off: Pre-select a time that will turn the unit ON / OFF automatically at
specified times (between 1-12hrs).
Note: These functions must be performed daily, as the program is automatically
canceled/erased after the program has ended.
a) Press CLOCK button, LCD clock display flashes. Press UP or DOWN: for every second
held, the LCD clock display changes setting by 1 min. intervals.
b) Press (UP) or (DOWN) and hold for more than 1 second. The LCD clock display
changes setting by 30 min. intervals.
c) When setting is complete, press the CLOCK button again to confirm the setting. LCD will
stop displaying CLOCK and will display the set time.
After discharging water from the tank (See “Draining Excess
Water” on pg. 5 ), please press the POWER ON/OFF button to
operate the unit. The unit will continue to operate in the mode that
was operating before emptying the tank.
A signal is given after approximately 650 hours of operation in
order to prevent you from forgetting to replace the filter. A light on
the front of the device will illuminate (Fig. X). The indicator light
will be displayed ONLY when in running mode.
When default indicator lights are illuminated, this indicates internal wiring failure.
If you see the above two failure lights, please contact your qualified service technician.
When the water tank is full, the RED LED indicator flashes (Fig. W)
and the unit stops running.
OPERATING INSTRUCTIONS (cont’d)
AUTO TIMER
CLOCK TIMER
DEFAULT INDICATOR
FILTER CLEANING
INDICATOR
Fig. X
WATER TANK
FULL INDICATOR
Fig. W
10