Cabasse STREAM source - Manuel (Page 22)

22 23
AUTO UPDATE
The updates of the firmware for Stream Source are done auto-
matically in 2 steps.
Step 1: download of the new version via internet. The “Power”
LED 1 flashes quickly. The Stream Source can play tracks.
Step 2 : install of the new version with a restart of the network
card.
The “Power” LED 1 turns red for around 25 seconds and
comes back to green when the install is completed. The sound
is temporarily muted and comes back at default level (30%).
CLEANING
The Stream Source satellites and subwoofer may be cleaned
with a soft damp cloth. Do not use any sprays near the system
or allow liquids to spill into any openings. Also, do not use any
solvents, chemicals, or cleaning solutions containing alcohol,
ammonia, or abrasives.
FAQ
Looking for more information? Read our detailed answers to the
Frequency Asked Question on www.cabasse.com, page Stream
Source
CUSTOMER SUPPORT SERVICE
The Cabasse retailer network is at your disposal to ensure the
after sale service of your product. To get the list of Cabasse
retailers, contact us or consult our web site
www.cabasse.com.
OPTIMISATION FOR USE WITH A TV-SET
Use the original TV remote control to select the following set-
tings when available:
- TV loudspeakers disconnection: it avoids any risk of parallel
playing of the TV speakers with Stream Source. If this option
is not available in the TV set-up menu, lower the TV volume
control down to the minimum value.
- SPDIF delay : the SPDIF digital link offers the best audio qua-
lity. It may create a noticeable delay in the sound/image syn-
chronisation. Use the “SPDIF delay” or the “Lipsync” option in
the TV set-up menu. “Lipsync” stands for lip synchronisation
and the best solution to calibrate the delay is to compare the
movements of the lips with the sound of the voice.
- Connection of additional sources : all video sources should
be, when possible, linked to the TV-set using HDMI inputs for
best video and audio results.
- Remote control(s): Use the Stream remote control for sound
and the original remotes of each source.
bATTERIES REPLACEMENT
Take the remote control in your hand with the keyside facing
the floor. Lift the locker and pull out the battery. Remove the
dead battery and replace it with a new CR-2025 battery. Dis-
pose of the old batteries according to these instructions.
WEEE MARK
Disposal of Wastes of Electrical & Electronic
Equipment (Applicable in the European Union)
This symbol on the product, consisting of the cros-
sed-out wheeled bin, indicates that this product
shall not be treated as household waste. Instead
it shall be handed over to the applicable collec-
tion point for the disposal of electrical and elec-
tronic equipment at the end of life. By ensuring this product is
disposed of correctly, you will help prevent potential negative
consequences for the environment and human health, which
could otherwise be caused by inappropriate waste handling of
this product. The recycling of materials will help to preserve na-
tural resources. For more detailed information about recycling
of this product, please contact your local city office, your house-
hold waste disposal service or the shop where you purchased
the product.
Attention: avoid shutting down the system during
update.
CAUtion: there is a danger of explosion if the battery is
incorrectly replaced. Replace only with the same or equi-
valent type. The battery shall not be exposed to excessive
heat such as sunshine, fire or the like.
e n g l i s h