Care and maintenance – DCS 36-48" BGB Grill BGB48-BQR Manuel d'utilisation

Page 32

Advertising
background image

30

Note:

When replacing grill and/or smoker burners, or orifices following cleaning, confirm orifice penetration into burner as
shown in Fig. 48

Be careful not to upset the air shutters’ original
position (unless readjusting). Lower the rear of the
burner into the cutouts on the support channel at the
rear of the burner box. Make sure it is level and does
not rock. Light all of the burners and check for proper
flame characteristics. If adjustments are necessary,
refer to page 17. Do this prior to cooking on the grill.

SIDE BURNERS (BGB48 BQR MODEL):

For proper lighting and performance keep the burners
clean. It is necessary to clean the burners if they do
not light even though the electrode clicks, if there has
been a severe boil over, or when the flame does not
burn blue. Be certain all burner knobs are in the off
position before attempting to clean the burners. The
burners have been designed for ease in cleaning.
When the grates and burners are cool, remove the
grate. The burner cap and the brass port ring can
easily be lifted off. Wash these parts in hot soapy
water, rinse and dry thoroughly. The burner caps are
porcelain enamel. Follow the directions on the
previous page for cleaning that were given for the
burner grates. A bristle brush can be used to clean
out the toothed burner ports, if necessary. After
cleaning, it is important to make sure the location pins
on the bottom side of the port ring are properly
aligned with the corresponding holes in the base.
Incorrect alignment will produce a potentially dangerous flame and poor burner performance (see Fig. 49).

SMOKER BURNER:

The smoker burner can be removed and cleaned by unplugging the electrode wire and lifting out the burner.
Cleaning is similar to the grill burner. Replace the burner by sliding the air shutter over the brass orifice,
centering it in the hole.

CARE AND MAINTENANCE

FIG. 49

Brass Ring Locat-
ing Pins

Electrode

Main
Burner
Port Ring

Locating Notch

Burner
Base

Venturi

Locating Holes

Cap

Fig. 48

Advertising
Ce manuel est liée aux produits suivants: