Paradigm Soundscape - Manuel (Page 10)

EN-9
POWER CONNECTION
The power cord should be inserted into the AC power
receptacle on the rear panel, then to a nearby AC wall outlet.
The Soundscape integrates a signal sensing power supply
that automatically switches to ‘Standby’ after 20 minutes.
Plugged into the wall, with no signal sensed, the Soundscape
will remain in standby mode.
SIGNAL CONNECTION
When using the Soundscape to reproduce TV audio, your
television’s audio output should be defeated. Some televisions
will allow you to turn off the internal speaker via the television’s
menu system. Others may require you to turn the television’s
volume to ‘zero’ or ‘mute’. Follow the instructions in your TV’s
Owners Manual to zero or mute the volume.
WHERE ARE CONNECTIONS MADE?
Audio connections are made at the signal input section on
the unit’s rear panel and wirelessly for Bluetooth. Five inputs
are available (Fig. 9):
• 2 x Digital Optical inputs
• 1 x Digital Coaxial (RCA) input
• 1 Pair x Left/Right Analog (RCA) inputs
• Bluetooth (wireless)
WARNING! CUSTOMERS OUTSIDE OF
NORTH AMERICA: If you remove your
Soundscape from the region or country of
original sale, make certain the AC power
supplied inthe new area is suitable before connecting
and operating your Soundscape. Substantially
impaired performance or severe damage may occur
if operation is attempted from an incorrect AC power
source. Such damage is not covered under the
product’s warranty.
CONNECTION
WARNING! ACTION REQUIRED: Turn the Soundscape system OFF before making or breaking any signal
connections! The power cord should NOT be installed, removed or left detached while the other end is still
connected to an AC power source.
Analog In
AC Power In
Coax In Sub Out
Optical In
1 2
Fig. 9