Traxxas 6509X TQi 2.4GHz - Manuel (Page 4)

4 • TQ i RADIO SYSTEM
Installing Transmitter Batteries
Your TQi transmitter uses 4 AA batteries. The battery compartment is
located in the base of the transmitter.
1. Remove the battery
compartment door by
pressing the tab and
sliding the door open.
2. Install the batteries in
the correct orientation
as indicated in the battery
compartment.
3. Reinstall the battery door
and snap it closed.
4. Turn on the transmitter and
check the status LED for a
solid green light.
If the status LED flashes red, the transmitter batteries may be weak,
discharged or possibly installed incorrectly. Replace with new or
freshly charged batteries. The power indicator light does not indicate
the charge level of the battery pack installed in the model. Refer to
the Troubleshooting section on page 12 for more information on the
transmitter status LED codes.
TQi Radio System Basic Adjustments
Steering Trim
The electronic steering trim located on the face of
the transmitter adjusts the neutral (center) point of
the steering channel.
Multi-Function Knob
The Multi-Function knob can be programmed to
control a variety of functions. From the factory, the
Multi-Function knob controls steering sensitivity,
also known as exponential or “expo.” When the knob is turned
counterclockwise all the way to the left (default position), expo is off
and steering sensitivity will be linear (the most commonly used setting).
Turning the knob clockwise will “add expo” and decrease the steering
sensitivity in the initial range of steering wheel travel left or right from
center. For more detail on steering exponential, refer to page 7.
Throttle Neutral Adjustment
The throttle neutral adjustment is located on the transmitter face and
controls the forward/reverse travel of the throttle trigger. Change the
adjustment by pressing the button and sliding it to the desired position.
There are two settings available:
50/50: Allows equal travel for both acceleration and reverse.
70/30: Allows more throttle travel (70%) and less reverse travel (30%).
We strongly recommend to leave this control in its factory location until you
become familiar with all the adjustments and capabilities of your model.
Note: 50/50 is the default factory setting and the required setting for
Traxxas nitro models. To change the throttle neutral adjust position for
an electric model, turn the transmitter off before adjusting the neutral
position. You will need to reprogram your electronic speed control to
recognize the 70/30 setting. See your speed control’s instructions.
Use the Right Batteries
Your transmitter uses AA batteries. Use new alkaline batteries.
Do not use rechargeable AA cells to power the TQi transmitter, as they
will not provide sufficient voltage for optimum transmitter performance.
Caution: Discontinue running your model at the first sign of weak
batteries (flashing red light on the transmitter) to avoid losing control.
GETTING STARTED