Coleman C270A Series - Manuel (Page 5)

English-4
■ Take lantern outdoors away from ignition sources.
■ Turn fuel valve off. (Fig. 12)
■ Note: Use Campingaz ® CV270 or CV470
disposable butane/propane mix cylinder only.
Do not connect to bulk LPG systems. The
LP-gas cylinder(s) used with lanterns must be
constructed and marked in accordance with the
specifications for LP-gas cylinders of the U.S.
Department of Transportation or
Transport
Canada, CAN/CSA B339 .
Fig. 12
DANGER
• EXPLOSION - FIRE HAZARD
• LPG is heavier than air and can accumulate in
low places. If you smell gas, leave the area
immediately.
• Always attach or detach LPG source
outdoors; never while lantern is lighted, near
flame, pilot lights, other ignition sources or
while lantern is hot to touch.
• Always light & use lantern outdoors.
• This lantern must not be exposed to
flammable vapors or liquids during lighting.
• This lantern is very hot during use and can
ignite flammables too close to the mantles.
Keep flammables at least 24 inches (60 cm)
from the sides and 48 inches (120 cm) from
the top of the lantern. Keep gasoline and
other flammable liquids and vapors well away
from lantern.
■ Move Easy Clic
TM
handle to the left.
(Fig. 13)
■ Align lantern with
cylinder outlet and
press onto cylinder.
Move Easy Clic
TM
handle to center to
lock. (Fig. 14)
Fig. 13 Fig. 14
Match Light Lantern
CAUTION
• SERVICE SAFETY
• Keep all connections and fittings clean.
Inspect LPG cylinder and lantern LPG
connections for damage before attaching.
• During set up, check all connections and
fittings for leaks using soapy water. Bubbles
indicate a leak. Never use a flame.
WARNING
• BURN HAZARD
• Never leave lantern unattended when hot or
in use.
• Keep out of reach of children.
Fig. 15
■ Brightness may be adjusted with FUEL VALVE.
(Fig. 17)
Fig. 17
■ Hold lighted match near top of MANTLE and
open FUEL VALVE fully until lantern ignites.
(Fig. 15)
■ During operation, hold or hang the lantern by the
CHAIN. Burn in upright position only. (Fig. 18)
Fig. 18
Electronic Ignition Lantern
■ Open FUEL VALVE fully and press IGNITOR as
needed to ignite. (Fig. 16)
Fig. 16