Chamberlain 3800PC - Manuel (Page 30)

30
Programming
To Add or Reprogram a Hand-held Remote Control (Model
895MAX)
To deactivate any unwanted remote, fi rst
erase all codes:
Press and hold the “learn” button on garage
door opener until the learn indicator light
goes out (approximately 6-9 seconds). All
previous codes are now erased. Reprogram
each remote or keyless entry you wish
to use.
1
NOTICE: If this Security ✚ ® garage door
opener is operated with a non-rolling
code transmitter, the technical measure
in the receiver of the garage door opener,
which provides security against code-
theft devices, will be circumvented. The
owner of the copyright in the garage door
opener does not authorize the purchaser or
supplier of the non-rolling code transmitter
to circumvent that technical measure.
To Erase All Codes From
Garage Door Memory
USING THE “LEARN” BUTTON USING THE SMART
CONTROL PANEL
®
To enter programming mode, press the Program button until the LEDs on the front of
the remote control turn on.
Press and release the Learn button on
the garage door opener. The Learn LED
will light. Within 30 seconds... Press and release the Prog <Learn>
button on the Smart Control Panel
®
twice. Within 30 seconds...
Safety Pin or
Paper Clip
OR
Learn LED
Prog <Learn> Button
Press and release the remote control button you want to use...
Check to see if the garage door opener
light bulb blinks. If not, wait for the
remote control LED to light solid then
slowly press and release the remote
control button again. Repeat until the
light bulb blinks. DO NOT press the
button after the light bulb blinks.
To exit programming mode, press any remote control button except the button that
was just programmed.
Your garage door opener has already been programmed at the factory to operate
with your hand-held remote control. The door will open and close when you press
the button shown.
Below are instructions for programming your garage door opener to
operate with additional 895MAX remote controls. To program additional
remote controls, refer to the instructions provided with the remote
control.
2
3
4
2
Factory Programmed Button
LEDs