Chamberlain 3800PC - Manuel (Page 12)

12
The remote light (garage door opener light)
is designed to plug directly into a standard
120V outlet. Select an appropriate location
on the ceiling to mount the light within 6
feet (1.8 m) of an electrical outlet so that
the cord and light are away from moving
parts.
Install the hinge and latch clips. Clips
slide in between the metal plate and
the plastic housing on each side of the
light base.
Install the mounting plate with the
screws provided. Leave 1/8" (3.1 mm)
of the thread exposed between the
ceiling and the screw head.
NOTE: If installing light on drywall and
a ceiling joist cannot be located, use
wall anchors provided. No pilot hole is
required for wall anchors.
Determine the length of power cord
needed to reach the nearest outlet.
Wind any excess cord around cord
retainer on the top side of the light
base.
Install the light base by pushing onto
the screws and turning the base
clockwise to lock the light in place.
Install two Type A19 incandescent or
compact fl uorescent bulbs. 100 watt
maximum per bulb, 200 watts total.
Install the light lens by hooking one
end of the lens over the hinge and
pressing up on the other end to latch
into place.
Plug in the light to outlet.
NOTE: Light will not operate until the
garage door opener is activated.
Install Remote Light
1
1
1
2
2
3
3
4
4
5
5
6
6
7
6
Installation
To prevent possible OVERHEATING of
the endpanel or light socket:
• DO NOT use short neck or specialty
light bulbs.
• DO NOT use halogen bulbs. Use
ONLY incandescent.
To prevent damage to the opener:
• DO NOT use bulbs larger than 100W.
• ONLY use A19 size bulbs.
IMPORTANT INSTALLATION INSTRUCTIONS
To reduce the risk of SEVERE INJURY or DEATH:
WARNING WARNING
1. This portable luminaire has a polarized plug (one blade
is wider than the other) as a feature to reduce the risk of
electric shock.
2. This plug will fi t in a polarized outlet ONLY one way.
3. If the plug does not fi t fully in the outlet, reverse the plug.
4. If it still does not fi t, contact a qualifi ed electrician.
5. NEVER use with an extension cord unless plug can be
fully inserted.
6. DO NOT alter the plug.
7. Light is intended for ceiling mount and indoor applications
ONLY.
Latch Clip
Light Clip
Screw
Screws Light Lens
Wall Anchor
Cord
Retainer
100 Watt
(max.)
Metal
Plate
Plastic
Housing
Hinge Clip
Wall Anchor (2)
HARDWARE
Light Clip Screw
#4-20x7/16" (2)
Screw
#6x1" (2)