Chamberlain 3800PC - Manuel (Page 25)

25
Operation
To prevent possible SERIOUS INJURY
or DEATH:
• NEVER allow small children near
batteries.
• If battery is swallowed, immediately
notify doctor.
To reduce risk of fi re, explosion or
chemical burn:
• Replace ONLY with 3V2016 coin
batteries.
• DO NOT recharge, disassemble, heat
above 100° C (212° F) or incinerate.
NOTICE: To comply with FCC and or Industry Canada (IC)
rules, adjustment or modifications of this receiver and/or
transmitter are prohibited, except for changing the code
setting or replacing the battery. THERE ARE NO OTHER
USER SERVICEABLE PARTS.
Tested to Comply with FCC Standards FOR HOME OR
OFFICE USE. Operation is subject to the following two
conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that may
cause undesired operation.
3-Button Remote Controls
Additional buttons on the remote control
can be programmed to operate up to 3
devices such as additional garage door
openers, light controls, gate operators or
access control systems.
Press and hold the button down until
the door or gate starts to move. The
remote control will operate from up to 3
car lengths away on typical installations.
Installations and conditions vary, contact
an installing dealer for more information.
Using the Remote Control
To Control the Opener Lights
Additional buttons on the remote control
can be programmed to operate the garage
door opener lights without opening the
door.
1. With the door closed, press and hold the
remote button that you want to control
the light.
2. Press and hold the Light button on the
Smart Control Panel ® .
3. Press and hold the Lock button on the
Smart Control Panel ® .
4. After the opener lights fl ash, release all
buttons.
Test by pressing the remote push button.
The opener lights should turn on or off but
the door should not move.
The Remote Control Battery
The LED(s) on your remote control will stop fl ashing when the battery is low and needs
to be replaced. To replace battery, open the case as shown. Insert battery positive side
up (+). Replace the battery with only 3V2016 coin cell batteries. Dispose of old battery
properly.
Remove the two screws
and open the case.
3V2016